Hamilton Beach Commercial 908 Série Manuel D'utilisation page 8

Caring for the Blender
Replacing the Cutter Unit Assembly
wWARNING
Cut Hazard
Always place cover on container when
blending.
Do not put hands, spoons, or other utensils
in container when blending.
Failure to follow these instructions can result
in broken bones, cuts, or other injuries.
Replacing the cutter unit assembly
The cutter unit assembly should be checked daily
for worn, loose, or damaged blades. If the cutter
unit assembly is worn or damaged, it should be
replaced immediately.
1. Loosen the collar on the bottom of the container.
2. Remove the cutter unit assembly and gasket
from the bottom of the container.
3. Place the gasket on the cutter unit assembly,
then install the new cutter unit assembly in the
bottom of the container.
4. Securely tighten the collar onto the bottom of
the container.
5. The rubber clutch disc on the blender base has
reverse threads. To replace , remove the rubber
clutch disc by threading it clockwise. To install
the new clutch disc, thread it onto the motor
shaft counterclockwise.
8
Gasket
Cutter Unit
Assembly
Collar
Rubber
Clutch Disc