If not used properly this product can be dangerous This product can cause serious injury to the operator
and others, the warnings and safety instructions must be followed to ensure reasonable safety and
efficiency in using this product. The operator is responsible for following the warning and safety
instructions in this manual and on the product.
Explanation of Symbols on the product
Warning
Read the user instructions carefully to make
sure you understand all the controls and what
they do.
Always keep the product on the ground when
operating. Tilting or lifting the product may
cause stones to be thrown out.
Keep bystanders away. Do not operate whilst
people especially children or pets are in the
area.
Switch off Remove plug from mains before
adjusting, cleaning or if cable is entangled or
damaged. Keep the cable away from the blade.
Beware of severing toes or hands.
Do not put hands or feet near a rotating blade.
Blade continues to rotate after the machine is
switched off. Wait until all machine components
have completely stopped before touching them.
STOP
Keep the supply cable away from the blade.
General
1. This product is not intended for use by persons including
children with reduced physical, sensory or mental
capabilities, or lack of experience and knowledge, unless
they have been given supervision or instruction
concerning the use of the product by a person
responsible for their safety. For safety reasons, children
under the age of 16 or people who are not familiar with
these operating instructions should not use this product.
2. Never allow children or people unfamiliar with the
instructions to use the machine.
3. Stop using the machine while people, especially
children, or pets are nearby.
4. Only use the product in the manner and for the
functions described in these instructions.
5. Never operate the product when you are tired, ill or
under the influence of alcohol, drugs or medicine.
6. The operator or user is responsible for accidents or
hazards occurring to other people or their property.
7. Read the user instructions carefully to make sure you
understand all the controls and what they do.
Electrical
1. The use of a Residual Current Device R.C.D. with a
tripping current of not more than 30mA is
recommended. Even with a R.C.D. installed 100
safety cannot be guaranteed and safe working
practice must be followed at all times. Check your
R.C.D. every time you use it.
2. Before use, examine the cable for signs of damage or
ageing. If the cable is found to be defective, take the
product to an Authorised Service Centre and have the
cable replaced.
3. Do not use the product if the electric cables are
damaged or worn
4. Immediately disconnect from the mains electricity
supply if the cable is cut, or the insulation is damaged.
Do not touch the electric cable until the electrical
supply has been disconnected. Do not repair a cut or
damaged cable. Replace it with a new one.
Safety
5. Your extension cable must be uncoiled, coiled cables
can overheat and reduce the efficiency of your mower.
6. Keep cable away from product, always work away from
the power point mowing up and down, never in circles.
7. Do not pull cable around sharp objects.
8. Always switch off at the mains before disconnecting
any plug, cable connector or extension cable.
9. Switch off, remove plug from mains and examine
electric supply cable for damage or ageing before
winding cable for storage. Do not repair a damaged
cable, replace it with a new one. Use only genuine
replacement cable.
10. Always wind cable carefully, avoiding kinking.
11. Never carry the product by the cable.
12. Never pull on the cable to disconnect any of the plugs.
13. Use only on AC mains supply voltage shown on the
product rating label.
14. Our products are double insulated to EN60335.
Under no circumstances should an earth be
connected to any part of the product.
Cables
If extension cables are used, these must comply with the
minimum cross-sections in the table below:
Voltage
220-240V/ 50Hz
220-240V/ 50Hz
1. Mains cables and extensions are available from your
local Approved Service Centre.
2. Only use extension cables specifically designed for
outdoor use and which conform to one of the following
specifications: Ordinary rubber 60245 IEC 53 , Ordinary
PVC 60227 IEC 53 or Ordinary PCP 60245 IEC 57
3. If the short connection lead is damaged, it must be
replaced by the manufacturer, its service agent or
similarly qualified persons in order to avoid a hazard.
Preparation
1. While using your product always wear substantial
footwear and long trousers. Do not operate the
equipment when barefoot or wearing open sandlas.
2. Make sure the lawn is clear of sticks, stones, bones,
wire and debris they could be thrown by the blade.
3. Before using the machine and after any impact, check
for signs of wear or damage and repair as necessary.
4. Replace worn or damaged blades together with their
fixings in sets to preserve balance.
Use
1. Use the product only in daylight or good artificial light.
2. Avoid operating your product in wet grass, where
feasible.
3. Take care in wet grass, you may lose your footing.
4. On slopes, be extra careful of your footing and wear
non-slip footwear. Do not mow on excessively steep
slopes.
5. Operate your product across the face of slopes, never
up and down.
6. Exercise extreme caution when changing direction on
slopes. Walk never run.
7. Make sure you always take up a safe and stable stance
whilst working, especially on slopes. Do not use the
mower close to swimming pools or garden ponds.
8. Do not walk backwards when operating, you could trip.
9. Never cut grass by pulling the product towards you.
10. Switch off before pushing the product over surfaces
other than grass.
11. Never operate the product with damaged guards or
without guards in place.
12. Switch on the motor according to instructions and
with feet well away from the blade s .
13. Do not tilt product when the motor is running,
14. Do not put hands or feet near or under rotating parts.
15. Never pick up or carry a product when it is operating
or still connected to the mains supply.
ENGLISH - 1
Cable
Cross
length
section
Up to 20 m
1.5 mm
20 - 50 m
2.5 mm
2
2