ArmorAll AA12V1 Manuel D'utilisation page 5

WARNING:
Extended use of the vacuum will drain the car battery power.
OPERATING INSTRUCTIONS – DRY VACUUMING
The vacuum can be used as assembled or with the crevice tool. For your convenience, the crevice tool is
permanently built-in onto the top portion of the container.
1. Verify that the switch is in the OFF position before plugging in. (fig. 1)
2. Flip the crevice tool over to the fully extended position and push it into the container nozzle until secured
in place. (fig. 2)
3. Insert the detail brush into the front of the crevice tool. (fig. 3)
4. Turn the motor on by sliding the switch to the ON position. (fig. 4)
5. After use, turn the vacuum OFF by sliding the switch to the OFF position. (fig. 4)
6. Remove detail brush from the crevice tool and store it. (fig. 5)
7. Pull the crevice tool out of the container nozzle and flip it forward towards the front of the unit and lock
into place. (fig. 6)
8. Empty the container, clean and dry the inside and outside before storage. (fig. 7 & 8)
OPERATING INSTRUCTIONS – WET VACUUMING
The vacuum can be used for wet pick up with or with out the use of the squeegee nozzle (J). For use with
the squeegee nozzle:
1. Verify that the switch is in the OFF position before plugging in. (fig. 1)
2. Fit the squeegee nozzle into the nozzle opening on the container. (fig. 2)
3. Insert the plug into the 12V power socket. (fig. 3)
4. Turn the motor on by sliding the switch to the ON position and vacuum. (fig. 4)
5. When finished vacuuming, slide the power switch to the OFF position and disconnect the plug from the
12V power socket. (fig. 5)
6. After use, empty the container, clean and dry the inside and outside before storage. (fig. 6 & 7)