Cembre B1350-C Notice D'utilisation Et Entretien page 11

125.2 kN
F = 125.2 kN
m
102.3 kN
692 bar P = 692 bar
m
565 bar
max. min.
The capacitive menu selection button may not work if touched using objects or when wear-
ing gloves, therefore always operate it using a bare finger.
BATTERY BATTERY
4.2) SELECTION SCREENS:
of the tool, can be changed by operating the touch button:
Enabling/disabling the LED Worklights
LED
BATTERY 
ON

LED
OFF
BATTERY
Return to original factory settings / firmware version
30001

When the "RESET" screen is displayed, return the tool to its factory setting by operating the touch
button for at least 3 seconds; a beep will confirm the setting.

RESET
SW:S1J41413
4.3) WARNINGS:
BATTERY 
LED
OFF 
LED
BATTERY
ON
30001


RESET
SW:S1J41413
11
B1350
OK
13AB485
To make a selected screen operational and appear at each start-up of the
OK
tool, operate the touch button for at least 3 seconds; a continuous beep
3 SEC.
will confirm the setting.


control parameters that cannot be set as automatic upon start-up
3 SEC.
The RESET screen also shows the firmware version of the circuit board.
these appear during operation and notify the operator of the status of the tool:
LOW BATTERY: replace the battery.
NOTE: when the battery Vage falls below a minimum safety threshold, the tool
will not start; although it is still possible to end the work cycle in progress.
BATTERY TEMPERATURE HIGH: remove the battery and wait until it cools down.
NO. OF CYCLES TO MAINTENANCE REACHED:
the tool continues to work however, it is recommended that it is sent to Cembre
for a complete overhaul (see § 6).
NOTE: this message, together with a beep, will reappear when the tool has been
idle for 30 seconds.
BATTERY 
BATTERY
30001


RESET
SW:S1J41413
(factory setting LED ON)
LED

OFF
ERROR

LED
ON

001


002


003


004


ERROR


001


002


003


004


When the screen is displayed,
touch the button for at least 3 sec-
onds to deactivate for reactivate
operation of the LED Worklights
during tool use;
a continuous beep will confirm
the setting.
ERROR


001


002


003


004
