Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
• Having the reception completed, it is best to pack the equipment in its original package until it is put into service in order
to protect it from mechanical impacts, dust, dirt, etc.
• The equipment packaging consists of a wooden pallet, cardboard or wooden package depending on the case, butt plates
protectors of expanded polyesthylene (EPS) or polyethylene foam (PE), polyethylene wrap and polyester strap. All of them are
recyclable materials, therefore if they are to be disposed, it must be done according to the effective laws. We recommend to
keep the packaging in case it would have to be used in the future.
• Until the moment of its definitive installation, it is convenient not to download the equipment of its wooden pallet with the
purpose of facilitating its mobility.
• Check that, together with the equipment, the Installation and User's manual is attached.
4.2.2.- Storing.
Due to the battery absence and/or other sensitive components to the ageing, the standards to follow for its correct storing will
be to store the unit in places free of dust and humidity and protected from chemical agents and high temperatures.
In case of piling up, do not exceed two units of height.
4.2.3.- Location.
The location of the equipment will depend on the version.
In case of outdoor units (I), the equipment must be placed over a pedestal and firmly anchored through bolts. Thanks to is
protection degree IP54, it can be located outdoors.
In case of the indoor units (T), the equipment, due to its protection degree IP20, must be placed inside an existing control centre,
never outdoor.
4.3.- Assembling of the different versions.
TYPE 1 - TYPE 2 - TYPE 3 - TYPE 7
TYPE 4 - TYPE 5 - TYPE 6
Depending on the equipment version either outdoor (I) or indoor (T),
the fixing drawing of the equipment baseboard will be as follows:
Types 1, 2 and 3: for all the indoor ILUEST version (T).
Types 4, 5, 6 and 7: for all the outdoor ILUEST version (I).
NOTE: The distance among the drills D, E, G, H and φ are stated in
the following table:
TYPE
ILUEST VERSION
Type 1
T -single phase-
T -three phase ≤ 45 kVA-
Type 2
Type 3
T -three phase > 45 kVA-
Type 4
I -single phase-
I -three phase ≤ 60 kVA-
Type 5
Type 6
I -three phase 80-100 kVA-
Type 7
I -three phase 120 kVA-
Fig. 10. Fixing drawing.
- 18 -
FIXING
∅ F
D
E
G
160
240
10,5
-
100
615
11
-
100
623
11
-
223
380
14
195
186
630
14
295
286
630
14
295
350
500
11
-
H
-
-
-
157,5
167,5
167,5
-
Publicité
Table des Matières
