Configuration Procedure - BORETTI BIZ-4 Mode D'emploi

Configuration procedure

The table must be configured. Please implement the following steps:
I) Important! Before you start, make sure there is no more pot on the hob
II) Disconnect the appliance from the grid by removing the fuse or turning the circuit breaker off
III) Reconnect the table to the grid
IV) Procedure:
* Take a pot with a ferromagnetic bottom with a minimum diameter of 16 cm
* start the procedure within 2 minutes after reconnecting the hob to the grid
* don't use the [ O/I ] touch
1
V) First step: cancel the existing configuration
1) Press the touch n°2 and hold down
2) The symbol [ - ] will appear on each display
3) With your other hand, press successively and quickly (less than 2s) on each [ - ] display.
Begin from the front right side and turn contrary clockwise, as described on the picture
(a -> b -> c -> d)). A double "beep" means an error occurred. If so, start again from item 1).
4) Remove your fingers from the touch control, then push again on touch 1 during few
seconds, until blinking [ E ] symbols appear.
5) Wait until [ E ] symbols stop blinking.
6) After few seconds, [ E ] are automatically transformed in [ C ].
The existing setup has been cancelled.
36
C
D
B
2 3
Slider
A