Assembling / Removing The Pedestal; When Using The Wall-Hanging Bracket - Panasonic TX-24D300E Mode D'emploi

Assembling / Removing the pedestal

Preparations
Take out the pedestal and the TV from the packing
case and put the stand onto a work table or any other
even surface.
• Use a flat and firm table or similar even surface that
can support the weight of the TV.
• Do not hold the screen panel part.
• Make sure not to scratch or break the TV.
Assembling the pedestal
1. Place the stand on the table or similar even
surface.
2. Hold the TV over the stand so that it coincides
with the stand mouinting point and then lower it
to be mounted with its own weight. If the stand
is not fitted properly, gently press down until the
latch/es snap/s into place.
Removing the pedestal from the TV
Be sure to remove the pedestal in the following way
when using the wall-hanging bracket or repacking
the TV.
• Put the TV onto a work table with the screen panel
down on the clean and soft cloth. Leave the stand
protruding over the edge of the surface.
• Press the button/s to release the latch/es.
• Remove the stand by pulling it away from the TV.

When using the wall-hanging bracket

Please contact your local Panasonic dealer to
purchase the recommended wall-hanging bracket.
Holes for wall-hanging bracket installation;
Rear of the TV
a (mm)
b (mm)
View from the side
Depth of
screw (a)
Diameter
Note: The screws for fixing the TV onto the wall-hanging
bracket are not supplied with the TV.
English - 4 -
a
b
75
75
a
min. (mm) 5
max. (mm) 7
M4