Danby Designer DUFM101A2WDD Manuel Du Propriétaire page 6

CARE & MAINTENANCE
CLEANING
Ensure the appliance is unplugged before cleaning.
• To clean the inside of the appliance, use a soft
cloth and a solution of a tablespoon of baking
soda to one quart of water or a mild soap
solution or some mild detergent.
• Clean the outside with a soft, damp cloth and
some mild detergent.
• It is important to keep the area where the door
seals against the cabinet clean to ensure a tight
seal. Clean this area with a soapy cloth. Rinse
with a damp cloth and let dry.
Note: Do not use cleaners containing ammonia or
alcohol on the appliance. Ammonia or alcohol can
damage the appearance of the appliance. Never
use any commercial or abrasive cleaners or sharp
objects on any part of the appliance.
DEFROSTING
This appliance should be defrosted approximately
twice a year or when a 6 mm (1/4 inch) layer of
frost has formed.
1. Turn the thermostat dial to the "0" position and
unplug the power cord.
2. Remove all contents and leave the door open.
3. As the frost melts, water will collect in the drip
tray in the bottom of the appliance.
4. Check the appliance frequently while defrosting
to ensure that water does not leak and cause
damage to fl ooring.
5. When all frost has melted, wipe the interior of
the appliance with a towel or sponge to ensure
it is completely dry before resuming operation.
6. Plug the appliance in, turn the thermostat dial
to the desired setting and replace all contents
once the appliance has reached the desired
temperature.
Important: Do not use pointed or sharp objects to
remove frost as this can damage the refrigerant
lines. If these lines are accidentally pierced it will
render the freezer inoperable and will void the
manufacturer's warranty.
POWER FAILURE
Most power failures are corrected within a few
hours and should not affect the temperature of your
appliance if you minimize the number of times the
door is opened. If the power is going to be off for
a longer period of time, take the proper steps to
protect your contents.
Note: Wait 3 to 5 minutes before attempting
to restart the refrigerator if operation has been
interrupted.
VACATION
• Short vacations: Leave the appliance operating
during vacations of less than three weeks.
• Long vacations: If the appliance will not be used
for several months, remove all items and turn off
the appliance. Defrost, clean and dry the interior
thoroughly. To prevent odor and mold growth,
leave the door open slightly, blocking it open if
necessary.
MOVING
• Remove all items.
• Tape the door shut.
• Be sure the appliance stays secure in the upright
position during transportation. Also protect the
outside of the appliance with a blanket or similar
item.
• If the appliance is placed on its back or side
during transportation, upon reaching the
destination, allow it to remain in its operating
position for 6 hours to avoid damage to internal
components.
DISPOSAL
This appliance may not be treated as regular
household waste, it should be taken to the
appropriate waste collection point for recycling
of electrical components. For information on local
waste collection points, contact your local waste
removal agency or government offi ce. Disposal of
this appliance should be in accordance with federal
and local regulations.
5