Casselin CLV35 Mode D'emploi page 25

Clean the tank, removing any residue and solid waste that may be there. Make sure that the rotating
wash spray arms are able to rotate.
Using a fine point, clean the holes in the nozzles which could be blocked by solid elements. Put all the
different elements back in place in reverse order. Leave the appliance door ajar when not in use.
To avoid the risk of oxidation or chemical attack of all kinds, always keep the surfaces of the steel
appliance very clean.
NEVER USE THE APPLIANCE WITHOUT ITS PUMP PROTECTION FILTER.
Periodic maintenance operations (to be done at least every 2 or 3 days).
NOTE : never wash the appliance by means of direct water jets or high pressure jets, in order to avoid any
possibility of infiltration liable to impair the correct functioning of the machine and its safety devices, and to
the risk of to lose the warranty.
 Completely drain the machine following the procedure described above.
 Switch off the device by pressing the line button (A1) (position "0").
 Switch off the power supply using the main switch located upstream of the appliance.
 Clean the tank filters and the pump filter.
 Remove the upper and lower rinsing spray rotating arms (C7) by unscrewing the central fixing ring.
 Check and clean all jets.
 Disassemble the rotating wash spray arms, upper and lower (C6), by removing them from the rotation
pins.
 Check and clean all jets.
 Thoroughly clean the tank.
 Put all the different elements back in place in reverse order.
 Leave the appliance door ajar when not in use.
 Clean the external surfaces of the device with soap and water, then rinse and dry them thoroughly.
NOTE : Never use steel shavings, straws or brushes to clean stainless steel.
After a certain number of uses, more or less variable according to the hardness of the water used, the
calcium salt and the magnesium present in the water form on the internal walls of the heating tank, pipes
and the tank, a layer of scale which, in the long run, can affect the proper functioning of the appliance. It is
therefore necessary to have the appliance periodically descaled by qualified personnel. In the event of an
anomaly in the operation of the machine or a breakdown, cut off the electric current by unplugging the main
switch and call a qualified assistance center.
Machine stop
In case of non-use for a long period of time, we recommend, for hygiene reasons, to carry out the following
operations:
 Fill the machine with water without detergent
 Run a few empty cycles
 Empty completely
Repeat this sequence several times until the drain water is completely clean, indicating that the dirt and
detergent residues have been completely removed. In the event of very long downtimes, complete the
operation by passing the stainless steel surfaces in petroleum jelly. To avoid any risk of ice formation, have
the water in the heating tank and in the internal circuits drained by qualified personnel.
NOTE The appliance is fitted with a safety system in the event of overheating. If tripped, unplug the device
and allow it to cool. If this protection system operates regularly, it is imperative to contact your dealer.
After automatic shutdown, the device can only be put into service by pressing the Reset button on the back
of the device, wait for the temperature to drop, press the Reset button.
EN