Side Burner Maintenance - Weber SUMMIT GRILL CENTER Mode D'emploi

SIDE BURNER MAINTENANCE

m WARNING: All gas controls and supply valves should be in
the OFF position.
Check Igniter Wires on the Underside of the Side Burner
Tools required: Phillips screwdriver .
A) To remove side burner cabinet back panel and side burner cabinet water deflector:
a) Facing the back of the unit, remove screws that secure back panel of side
burner cabinet with a Phillips screwdriver (1) .
b) Remove back panel and set aside .
c) Facing the front of the unit, open side burner cabinet door and remove screw
and washer securing side burner cabinet water deflector (2) .
d) Facing the back of the unit, push water deflector forward to allow rear edge
to drop down . Pivot water deflector down on an angle and remove from side
burner cabinet (3) .
B) Locate the igniter wires at the underside of the side burner (4) .
C) Make sure black wire (5) is connected to the black terminal clip on the ignition
module .
D) Make sure white wire (6) is connected to the white terminal clip on the ignition
module .
Note: Spark should be a white/blue color, not yellow.
MAINTENANCE
2
2
6
5
WWW.WEBER.COM
3
1
4
® 45