Weber SUMMIT GRILL CENTER Mode D'emploi page 17

A) Locate hose retention clip (1) on regulator hose . Secure into slot (2) on underside of
tank scale .
m WARNING: The hose must be secured to the tank scale
with the Hose Retention Clip. Failure to do so could cause
damage to the hose resulting in a fire or explosion which
can cause serious bodily injury or death, and damage to
property.
Some LP tanks have differing top collar assembles . (The top collar is the metal
protective ring around the valve .) One series of tanks mount with the valve facing front
(3) . The other tanks mount with the valve facing away from the fuel scale (4) . Weber
recommends the use of cylinder manufacturer's Manchester and Worthington, with a
47 .6 lb water capacity . Other cylinders may be acceptable for use with the appliance
provided they are compatible with the appliance retention means (see illustrations) .
The LP cylinder is installed inside the base cabinet, on the tank scale (right side) .
B) Open base cabinet doors .
C) Loosen cylinder lock wing nut . Swing cylinder lock up (5) .
D) Turn the LP cylinder so the opening of the valve is either to the front or side of the
Weber gas barbecue .
®
E) Lift tank up into position on the tank scale (6) .
F) Swing the cylinder lock down . Tighten the wing nut .
Connect The Hose To The Cylinder
A) Remove the plastic dust cover from the valve .
B) Screw the regulator coupling onto the tank valve, clockwise, or to the right . Hand-
tighten only (7) .
Note: This connection tightens clockwise and will not allow gas to flow unless the
connection is tight. The connection requires tightening by hand only.
m WARNING: Do not use a wrench to tighten the connection.
Using a wrench could damage the regulator coupling and
could cause a leak.
GAS INSTRUCTIONS
3
1
5
6
2
4
5
7
WWW.WEBER.COM
® 17