Sear Station ® Troubleshooting; Rotisserie Troubleshooting; Grill Out™ Handle Light Troubleshooting - Weber Summit 56580 Manuel De L'utilisateur

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

PRobLEm
burners burn with a yellow or orange flame, in
conjunction with the smell of gas (this is normal for
the burner lighting tube).
sear station
burner does not light.
®
if problems cannot be corrected by using these methods, please contact the Customer service representative in your area using the contact information on our
web site. log onto www.weber.com
PRobLEm
rotisserie burner does not light.
if problems cannot be corrected by using these methods, please contact the Customer service representative in your area using the contact information on our
web site. log onto www.weber.com
PRobLEm
weber Grill out™ handle light does not light.
if problems cannot be corrected by using these methods, please contact the Customer service representative in your area using the contact information on our
web site. log onto www.weber.com
28
SEAR STATIoN
Inspect Spider/Insect Screens for possible obstructions .
(Blockage of holes .)
Did you ignite the two adjacent main burners? (Refer to
"SEAR STATION
safe lighting procedure)
Does Burner light with a match?
Does the igniter work (Do you see a spark when you
repeatedly use the snap igniter?)
.
®

RoTISSERIE TRoUbLESHooTING

Did you hold the burner control knob in and hold in for 20
seconds until after burner ignited?
Did you wait to see the entire ceramic surface become
alight before counting 20 seconds?
Did you repeatedly use the snap ignition until the burner
ignited?
Does the igniter work? (Do you see a spark when you
repeatedly use the snap igniter?)
.
®
GRILL oUT™ HANDLE LIGHT TRoUbLESHooTING
Are the batteries old?
Are the batteries installed correctly?
Is the lid in the up position with the power button ON?
Is the Weber Grill Out™ Handle Light activated?
Is the Weber Grill Out™ Handle Light positioned correctly
on the handle?
.
®
TRoUbLESHooTING
®
cHEcK
®
IGNITION & USAGE" instructions for
cHEcK
cHEcK
SoLUTIoN
Clean Spider/Insect Screens (refer to "ANNUAL
MAINTENANCE") .
Verify adjacent main burner ignition by visual inspection
of a flame .
m warninG: if ignition does not occur
in five seconds, turn burner control
off, wait five minutes to let the gas
clear before you try again
If you can light Burner with a match, then check the
Crossover
Channel on the sear burner (refer to
®
"MAINTENANCE" for burner removal and cleaning
procedure) .
Try manually lighting the burner (refer to "SEAR
STATION
®
IGNITION & USAGE") . Call customer service .
SoLUTIoN
Try to relight burner by holding burner control knob in
and continue holding in until 20 seconds after burner has
ignited .
When relighting burner by holding burner control knob
in, wait to see the entire ceramic surface become alight
before counting 20 seconds?
After waiting five minutes for gas to clear, try repeatedly
to use the snap igniter until the burner ignites . Refer to
"ROTISSERIE BURNER IGNITION & USAGE" .
Try manually lighting the burner . Refer to "ROTISSERIE
BURNER MANUAL IGNITION" . Call Customer Service .
SoLUTIoN
Replace batteries .
Refer to assembly illustration .
Light will activate when lid is open .
Press the power button .
Adjust position . Refer to assembly illustration .

Publicité

Table des Matières
loading

Table des Matières