• Do not turn off the power immediately after stopping operation.
- Always wait at least 5 minutes before turning off the power. Otherwise,
drainage water leakage or mechanical failure of sensitive parts may occur.
• Do not touch the surface of the compressor during servicing.
- If the unit is connected to a supply and not running, the crank case heater
located at the base of the compressor may still be operating.
2. About the product
• This unit uses R410A-type refrigerant.
• Piping for systems using R410A may be different from that for systems using
conventional refrigerant because the design pressure in systems using
R410A is higher. Refer to the Data Book for more information.
• Some of the tools and equipment used for installation with systems that use
other types of refrigerant cannot be used with the systems using R410A.
Refer to the Data Book for more information.
3. Combination of outdoor units
Component units of PURY-P168 to P288 are listed below.
Outdoor unit model
PURY-P72TKMU-U(-BS)
PURY-P96TKMU-U(-BS)
PURY-P120TKMU-U(-BS)
PURY-P144TKMU-U(-BS)
PURY-P168TSKMU-U(-BS)
PURY-P192TSKMU-U(-BS)
PURY-P216TSKMU-U(-BS)
PURY-P240TSKMU-U(-BS)
PURY-P264TSKMU-U(-BS)
PURY-P288TSKMU-U(-BS)
Component units of PURY-P144 to P288 are listed below.
Outdoor unit model
PURY-P72YKMU-U(-BS)
PURY-P96YKMU-U(-BS)
PURY-P120YKMU-U(-BS)
PURY-P144YKMU-U(-BS)
PURY-P144YSKMU-U(-BS)
PURY-P168YSKMU-U(-BS)
PURY-P192YSKMU-U(-BS)
PURY-P216YSKMU-U(-BS)
PURY-P240YSKMU-U(-BS)
PURY-P264YSKMU-U(-BS)
PURY-P288YSKMU-U(-BS)
4
Component unit model
-
-
-
-
PURY-P96TKMU-U(-BS)
PURY-P96TKMU-U(-BS)
PURY-P120TKMU-U(-BS)
PURY-P120TKMU-U(-BS)
PURY-P144TKMU-U(-BS)
PURY-P144TKMU-U(-BS)
Component unit model
-
-
-
-
PURY-P72YKMU-U(-BS)
PURY-P96YKMU-U(-BS)
PURY-P96YKMU-U(-BS)
PURY-P120YKMU-U(-BS)
PURY-P120YKMU-U(-BS)
PURY-P144YKMU-U(-BS)
PURY-P144YKMU-U(-BS)
• Do not use the existing piping, as it contains chlorine, which is found in
conventional refrigerating machine oil and refrigerant. This chlorine will
deteriorate the refrigerant machine oil in the new equipment. The existing
piping must not be used as the design pressure in systems using R410A
is higher than that in the systems using other types of refrigerant and the
existing pipes may burst.
-
-
-
-
PURY-P72TKMU-U(-BS)
PURY-P96TKMU-U(-BS)
PURY-P96TKMU-U(-BS)
PURY-P120TKMU-U(-BS)
PURY-P120TKMU-U(-BS)
PURY-P144TKMU-U(-BS)
-
-
-
-
PURY-P72YKMU-U(-BS)
PURY-P72YKMU-U(-BS)
PURY-P96YKMU-U(-BS)
PURY-P96YKMU-U(-BS)
PURY-P120YKMU-U(-BS)
PURY-P120YKMU-U(-BS)
PURY-P144YKMU-U(-BS)