Mounting Precautions; Specifications - Sharp PN-70TB3 Manuel D'installation

• This product is for use indoors.
• A mounting bracket compliant with VESA specifications is
required.
• Since the monitor is heavy, consult your dealer before
installing, removing or moving the monitor.
• Mounting the monitor on the wall requires special expertise
and the work must be performed by an authorized SHARP
dealer. You should never attempt to perform any of this
work yourself. Our company will bear no responsibility
for accidents or injuries caused by improper mounting or
mishandling.
• Use the monitor with the surface perpendicular to a level
surface. If necessary, the monitor may be tilted up to 20
degrees upward.
• When moving the monitor, be sure to hold it with the
handles and the unit bottom. Do not grasp the screen or
tray. This may cause product damage, failure, or injury.
• This monitor should be used at an ambient temperature
between 41°F (5°C) and 95°F (35°C). Provide enough
space around the monitor to prevent heat from
accumulating inside.
2
[5]
Model
Power requirement
Operating temperature *
Operating humidity
Power consumption (Maximum)
Dimensions (excluding protrusions) inch (mm) Approx. 64-13/16 (W) x 3-11/16 (D) x
Weight
* Temperature condition may change when using the monitor together with the optional equipments recommended by SHARP.
In such cases, please check the temperature condition specified by the optional equipments.
As a part of our policy of continuous improvement, SHARP reserves the right to make design and specification changes for product improvement
without prior notice. The performance specification figures indicated are nominal values of production units. There may be some deviations from
these values in individual units.
4
E

MOUNTING PRECAUTIONS

Unit: inch [cm]
7-7/8 [20]
1-7/16 [3.5]
2
[5]
2 [5]

Specifications

PN-70TB3
AC 100 V - 240 V, 2.6 A, 50/60 Hz
41°F to 95°F (5°C to 35°C)
20% to 80% (no condensation)
225 W
39-3/4 (H) (1647 x 94 x 1010)
lbs. (kg) Approx. 130.1 (59)
• If it is difficult to provide sufficient space for any reason
such as the installation of the monitor inside a housing, or
if the ambient temperature may be outside of the range
of 41°F (5°C) to 95°F (35°C), install a fan or take other
measures to keep the ambient temperature within the
required range.
• Temperature condition may change when using the monitor
together with the optional equipments recommended by
SHARP. In such cases, please check the temperature
condition specified by the optional equipments.
• Do not block any ventilation openings. If the temperature
inside the monitor rises, this could lead to a malfunction.
• Do not place the monitor on a device which generates heat.
• Do not use the product in locations where the unit is
exposed to direct sunlight or other strong light. Since this
product operates with infrared rays, such light may cause a
malfunction.
• When using multiple monitors closely, be sure the infrared
transmitter/receiver does not affect the other ones.
PN-60TB3
AC 100 V - 240 V, 2.2 A, 50/60 Hz
185 W
Approx. 56-9/16 (W) x 3-11/16 (D) x
35-1/16 (H) (1437 x 94 x 890)
Approx. 101.5 (46)