Philips SHC2000 Mode D'emploi page 7

SHC2000_booklet 12-01-2006
Audio Connections
Connecting the IR transmitter to a
headphone output of an audio
source (figure 5)
1 Connect the 3.5mm stereo plug of the
stereo audio cable to the headphone
output of an audio source, such as TV, HiFi
or PC.
– In case your audio source has a 6.3mm
headphone output, use the supplied
3.5mm to 6.3 mm stereo adapter plug.
2 Switch on your audio source and carefully
increase the volume of the audio source.
3 Switch on the headphone.
4 Adjust the volume to the desired level with
the headphone volume control.
11:05 Pagina 7
Audio Connections
Basic operation
When the IR transmitter is connected to a
headphone output of an audio source.
1 Switch on your IR transmitter and place it
at the same height or slightly higher than
the reception height of the IR headphone.
2 Position the LED's towards the listening
area, ensuring that there are no obstacles in
between transmitter and headphone.
3 Switch on the headphone.
4 Switch on your audio source and carefully
increase the volume of the audio source.
5 Adjust the volume of the IR headphone to
the desired level with the headphone
volume control.
IMPORTANT
Because IR light travels in a straight
line, place the IR transmitter at the
same height, or slightly higher than the
reception height of the IR headphone.
High IR light content such as sunlight
and bright incandescent indoor lighting
may degrade the audio signal and
cause interference. If you experience
such problems, simply move the system
to a darker area.
7