Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Setting the clearance.
Switch on the device.
There is an adjustment device on the right hand side of the plastic
housing. To adjust the distance turn the adjusting knob (D)
clockwisely so that the screw (C) moves toward the cutting roller.
Turn until fine aluminium chips are falling from the ejection slot.
M
a
i
n
t
e
n
a
M
a
i
n
t
e
n
a
•
Each time before starting maintenance work:
− Switch off the motor and pull out the mains plug.
− Wear protective gloves to prevent injury.
The cutters will not come to a standstill immediately after
cut-off. Before starting any service work wait until all parts
are stationary.
Before each fault elimination:
− Switch off device.
− Wait for standstill of the device.
− Pull out mains plug.
Fault
Motor does not start
Motor hums but does not
start
n
c
e
a
n
d
c
l
e
a
n
i
n
g
n
c
e
a
n
d
c
l
e
a
n
i
n
g
Possible cause
- Rotation selector switch on position "0"
- No power supply
- Mains cable defective
- Machine overloaded (motor protection)
- Cutting roller blocked
- Capacitor faulty
Be sure to have removed any tools from the machine after
completion of service work.
•
Generally garden shredders require little maintenance. To
maintain their efficiency and a long life, observe the fol-
lowing:
− Keep vent slits clean and free from obstructions.
− Check the locking screws (tighten where necessary).
− Clean the device after shredding.
To clean your product only use a warm moist cloth and a soft
brush.
Never use cleaning agents or solvents. Otherwise the device
may be damaged irreversibly. Plastic parts may be corroded
by chemicals.
− Do not clean the machine with running water or high-pressure
cleaners.
− After each operation treat bare metal parts with an environ-
−
ment-compatible biodegradable spray oil to protect them
against corrosion.
− the cutting roller and shaving plate are expendable parts,
though with normal use and correct adjustment they have a
service life of many years
O
p
e
r
a
t
i
o
n
a
l
f
a
u
l
t
s
O
p
e
r
a
t
i
o
n
a
l
f
a
u
l
t
s
Remedy
- Switch off device and switch over direction of rotation
selector switch.
- Check fuses
- have these checked (electrician)
- Allow the device to cool down.
Press the
1. reset button (motor protection)
2. green button
- Switch off the device.
Turn the direction of rotation selector switch into
position
cleared. Switch device off again. Turn back the
direction of rotation selector switch to position
- Bring machine to manufacturer or authorised work-
shop for repair
to restart.
. Switch on device until the jam has been
.
15
Publicité
Chapitres
Table des Matières
