Cleaning And Maintenance - EuroLite TG-5 Mode D'emploi

156-163 Gobo 2 shake with increasing speed
164-171 Gobo 3 shake with increasing speed
172-179 Gobo 4 shake with increasing speed
180-187 Gobo 5 shake with increasing speed
188-195 Gobo 6 shake with increasing speed
196-203 Gobo 7 shake with increasing speed
204-210 Gobo 8 shake with increasing speed
211-217 Gobo 9 shake with increasing speed
218-223 Sound-controlled
224-225 Stop
226-255 Cont. gobo-wheel rotation with increasing speed
Control channel 3 - Dimmer intensity
DMX-value Feature
0-255 Gradual adjustment of the dimmer intensity from 0 to 100 %
The operator has to make sure that safety-relating and machine-technical installations are inspected by an
expert after every four years in the course of an acceptance test.
The operator has to make sure that safety-relating and machine-technical installations are inspected by a
skilled person once a year.
The following points have to be considered during the inspection:
1) All screws used for installing the devices or parts of the device have to be tighly connected and must not
be corroded.
2) There must not be any deformations on housings, fixations and installation spots (ceiling, suspension,
trussing).
3) Mechanically moved parts like axles, eyes and others must not show any traces of wearing (e.g. material
abrading or damages) and must not rotate with unbalances.
4) The electric power supply cables must not show any damages, material fatigue (e.g. porous cables) or
sediments. Further instructions depending on the installation spot and usage have to be adhered by a
skilled installer and any safety problems have to be removed.
We recommend a frequent cleaning of the device. Please use a moist, lint-free cloth. Never use alcohol or
solvents!
The lens has to be replaced when it is obviously damaged,
so that its function is impaired, e. g. due to cracks or deep scratches!

CLEANING AND MAINTENANCE

The operator has to make sure that safety-relating and machine-technical installations are inspected by an
expert after every four years in the course of an acceptance test.
The operator has to make sure that safety-relating and machine-technical installations are inspected by a
skilled person once a year.
The following points have to be considered during the inspection:
5) All screws used for installing the devices or parts of the device have to be tighly connected and must not
be corroded.
DANGER TO LIFE!
Disconnect from mains before starting maintenance operation!
CAUTION!
25/51 51785850X88NXS_V_1_0.DOC