Operating Determinations - EuroLite Snow 6001 Mode D'emploi

This device falls under protection-class I. The power plug must only be plugged into a protection class I
outlet.
Always plug in the power plug least. Make sure that the power-switch is set to OFF position before you
connect the device to the mains.
Never let the power-cord come into contact with other cables! Handle the power-cord and all connections
with the mains with particular caution!
Make sure that the available voltage is not higher than stated on the rear panel.
Make sure that the power-cord is never crimped or damaged by sharp edges. Check the device and the
power-cord from time to time.
Never drink fluid or use it on the inside or outside of a human body. If fluid gets in contact with skin or eyes,
rinse thoroughly with water. If it is necessary call a doctor immediately!
Keep device upright.
For overhead use (mounting height >100 cm), always fix the fixture with an appropriate safety bond.
Always disconnect from the mains, when the device is not in use or before cleaning it. Only handle the
power-cord by the plug. Never pull out the plug by tugging the power-cord.
Unused machines must be disconnected from the mains. If the power plug or the power switch is not
accessible, the device must be disconnected via the mains.
Keep away children and amateurs!
Never leave this device running unattended.

OPERATING DETERMINATIONS

This device is a special effect machine for creating snow effects. This product is only allowed to be operated
with an alternating voltage of 230 V, 50 Hz and was designed for indoor use only.
Do not shake the device. Avoid brute force when installing or operating the device.
When choosing the installation-spot, please make sure that the device is not exposed to extreme heat,
moisture or dust. Please consider that liquid may be spilt during operation around the device. The resulting
slippery surface can cause accidents. There should not be any cables lying around. You endanger your own
and the safety of others!
Before filling the device disconnect from mains. Never fill in any hot liquids.
Operate the device only after having familiarized with its functions. Do not permit operation by persons not
qualified for operating the device. Most damages are the result of unprofessional operation!
Store dry!
Always drain the tank and please use the original packaging if the device is to be transported.
Please consider that unauthorized modifications on the device are forbidden due to safety reasons!
Never remove the serial barcode from the device as this would make the guarantee void.
If this device will be operated in any way different to the one described in this manual, the product may suffer
damages and the guarantee becomes void. Furthermore, any other operation may lead to dangers like short-
circuit, burns, electric shock, etc.
12/29 00035972.DOC, Version 1.1