Oreck XL2600HH Guide D'utilisation page 5

All paper dust bags are not the same. Your ORECK
disposable dust bags have been designed to be used with the
ORECK cleaner. Using bags other than genuine ORECK
disposable bags will affect the cleaning ability of your
cleaner and could cause damage to it.
The Belt
The belt on your vacuum cleaner controls the speed of the
revolving brush and is very important for the effective
operation of the cleaner. If the belt becomes stretched or cut,
it will cause the revolving brush to stop completely or slow
down. See instructions in the manual for replacing belt.
An extra belt is stored in the baseplate of your cleaner. When
buying replacement belts, use ONLY ORECK genuine belts.
Belts other than ORECK belts will not operate the revolving
brush correctly and may create undue stress which will cause
damage to the motor and brush bearings. Using belts other
than ORECK belts will void the warranty.
Lubrication
The vacuum cleaner motor bearings are factory lubricated
and seated. Further lubrication is not required.
General Cleaner Care
At least once a month, check for and remove excessive
lint, string or hair from revolving brush.
Wipe the outside of the cleaner with a damp cloth. Also
clean the connector deflector assembly area, base of
cleaner and fan housing area. If there is dust in the outer
bag, vacuum it or shake it out.
A little preventative maintenance will keep your cleaner
looking new and will ensure continued cleaning effectiveness.
CAUTION—Wood Floors
Use floor and floor finish manufacturer's recommended
methods of cleaning. The metal strip on the base of the
cleaner could be damaged if used on concrete or abrasive
surfaces, and, therefore, cause damage to wood floors. The
roller brush may also scuff very soft finishes. Do not operate
the unit while in the upright and locked position. Do not let
the unit run while in any one stationary position for any
period of time. Keep the unit moving while in operation.
XL2600HH & XL2700HH:
Celoc Hypo-Allergenic Filter System
®
The CELOC SMMS outer bag of your vacuum cleaner is high
filtration medical material designed to filter the smallest of
dust particles. It is important the inside of the outer bag be
cleaned. Vacuum the inside of the outer bag or hand wash,
turned inside out, with warm water, and air dry. For best
once a year. The CELOC layered disposable inner dust bag
results, the CELOC SMMS outer bag should be replaced
must be replaced once a month even if it is not full.
Change it more often if it is used in extremely dirty areas.
Increase the cleaning power of your vacuum by changing the
bag often.
E N G L I
5
S H
T R
o eplace
D B
ust ag
WARNING: Unplug cord from
electrical outlet before servicing.
BAG REMOVAL:
1. Pull bag cardboard collar to
release bag dock door from
connector. Bag dock door
will hinge downward.
2. Gently pull bag card
cardboard collar upward out
of the bag dock. Dust seal
will close automatically
BAG INSTALLATION:
1. Slide the cardboard collar
completely onto bag dock
door.
2. Firmly push bag dock door
with both thumbs on
indication point until
it snaps.
F
ilter
ENFONCEZ JUSQU'À
ENTENDRE UN BRUIT
PRESIONE HASTA
ESCUCHAR UN
CHASQUIDO DE SUJECIÓN