Publicité
Les langues disponibles
Les langues disponibles
OPERATING INSTRUCTIONS
• Securely fit the socket or attachment to the air ratchet.
• Ensure that the forward/reverse switch is in the correct
position for tightening or loosening the fastener.
• The nut/bolt can then run down the thread using the
power drive of the tool. For loosening a joint the tool can
be used in the reverse sequence.
MAINTENANCE
Lubrication
Air tools require lubrication throughout the lifetime of the tools.
The air motor and bearing uses compressed air to power the tool.
The compressed air contains moisture that will rust the air motor
and other parts in side of the tools, therefore lubrication is required
daily. Failure to lubricate the air tool properly will dramatically
shorten the life of the tool and will void the warranty
CAUTION: This air tool requires lubrication BEFORE initial use,
also before and after each additional use.
To Lubricate The Air Tool Manually:
1. Remove any attachment on the drive of air tools, such as:
sockets, chisels and etc.
2. Disconnect the tool from the air supply source, place
the air inlet face up.
3. Depress the trigger and place about 1 teaspoon
(5cc.) of air tool oil into the air inlet. (Depressing the trigger
will help circulate oil in the motor.)
NOTE: Use SAE #10 weight oil if air tool oil is not available.
4. Connect the tool to an air source, cover the exhaust end
with a towel and run for about 20 to 30 seconds.
WARNING: Keep out of the reach of children. If taken internally, do
not induce vomiting, call a doctor immediately.
WARNING: Any excess oil in the motor is immediately expelled
from the exhaust port. Always direct exhaust port away from people
or objects.
Storage:
The air tool must be lubricated before storing.
Follow the "Lubrication" instruction with exception of step 4.
SERVICE INFORMATION
Please have the following information available for all service calls:
Model Number ________________________________________
Date and Place of Purchase ______________________________
FULL THREE YEARS WARRANTY
D
WALT heavy duty industrial tools are warranted for 3 years from
e
date of purchase. We will repair, without charge, any defects due
to faulty materials or workmanship. For warranty repair information,
call 1-800-4-D
WALT. This warranty does not apply to accessories
e
or damage caused where repairs have been made or attempted by
others. This warranty gives you specific legal rights and you may
have other rights which vary in certain states or provinces.
Latin America: This warranty does not apply to products sold in
Latin America. For products sold in Latin America, see country
specific warranty information contained either in the packaging, call
the local company or see website for warranty information.
FREE WARNING LABEL REPLACEMENT: If your warning labels
become illegible or are missing, call 1-800-4-D
for a free replacement.
14
WALT
e
Publicité
