IV. USE OF INSTRUCTIONS
1. Precautions for use:
-
Before using this unit, make sure it is installed on a flat, stable surface.
-
Place the radiator at least 90 cm away from the wall, furniture or curtains.
-
Check that the voltage indicated on the rating plate of the appliance corresponds to
the voltage of your electrical installation.
-
Always cool the radiator before moving it. It must be handled by holding it by the
handles.
Attention :
-
Make sure the feet are properly assembled before operating the unit.
-
Never fix the convector to the wall.
-
This product can only be used in well isolated premises or occasionally.
2. Getting started:
Before connecting the power cord to a wall outlet, make sure that the thermostat control
and power selection switches are in the "Off" position.
• Connect your heater to a wall outlet.
• Switch on the radiator by pressing one or both switches according to the desired power.
3 operating modes are available:
-
Switch on the switch (I) to operate the radiator in 750 W
-
Switch on the switch (II) to operate the radiator in 1250 W
-
Switch on the switches (I + II) to operate the heater in 2000 W
-
Press the "TURBO" switch to activate ventilation.
The power switches turn on when the heater is running.
3. Thermostat function:
The room temperature can be adjusted using the thermostat.
Turn the thermostat knob clockwise to increase the temperature, or counterclockwise to
decrease it until the desired temperature is reached.
After reaching the desired temperature, to maintain the room temperature: Turn the
thermostat knob counterclockwise until the indicator light goes out. The desired
temperature will be kept constant by the function of the thermostat.
If the appliance is not in use, put both switches on "Off" and the thermostat knob on "MIN."
and then unplug the unit.
Remark:
-
The heater has a protection system against overheating.
ATTENTION :
Never cover or place objects on the radiator while it is running.
25