Zanussi ZFU27401WA Notice D'utilisation page 23

Problem
The appliance is noisy.
Power indicator light is flashing.
The compressor operates contin-
ually.
There is too much frost and ice.
Door is misaligned or interferes
with ventilation grill.
The temperature in the appliance
is too low/too high.
www.zanussi.com
Possible cause
There is no voltage in the
mains socket.
The appliance is not supported
properly.
An error has occurred in meas-
uring the temperature.
The appliance is not working
properly.
Temperature is set incorrectly.
Many food products were put
in at the same time.
The room temperature is too
high.
Food products placed in the
appliance were too warm.
The door is not closed correct-
ly.
The door is not closed correct-
ly or the gasket is deformed/
dirty.
The water drainage plug is not
correctly positioned.
Food products are not wrap-
ped properly.
Temperature is set incorrectly.
The appliance is not levelled.
The temperature regulator is
not set correctly.
The food products' tempera-
ture is too high.
The thickness of the frost is
greater than 4-5 mm.
Solution
Connect a different electrical appli-
ance to the mains socket. Contact
a qualified electrician.
Check if the appliance stands sta-
ble.
Contact a qualified electrician or
contact the nearest Authorised
Service Centre.
Contact a qualified electrician or
contact the nearest Authorised
Service Centre.
Refer to "Operation" chapter.
Wait some hours and then check
the temperature again.
Refer to climate class chart on the
rating plate.
Allow food products to cool to
room temperature before storing.
Refer to "Closing the door".
Refer to "Closing the door".
Position the water drainage plug in
the correct way.
Wrap the food products better.
Refer to "Operation" chapter.
Refer to "Levelling".
Set a higher/lower temperature.
Let the food products temperature
decrease to room temperature be-
fore storage.
Defrost the appliance.
23