Safety Instructions Regarding Installation; Technical Specification - Reer Rigi 400 Notice D'utilisation

! Always place the baby unit out of your child´s reach (minimum distance: 1 meter).
! Never place the baby monitor inside the crib, cot or playpen.
! The power lead must be secured out of the reach of children to avoid any risk of
strangulation. Do not use extension cables.
! To ensure optimal transmission, the units must be kept upright at all times and placed in
an elevated position.
! DO NOT place the receiver in the vicinity of radio transceivers or microwaves. Radiant
emissions from these devices can significantly affect radio reception.
! Do not use the units near water or in humid places. Do not submerge the units in water.
Do not rinse the units under running water.
! Do not cover the baby monitor with towels, clothes or blankets.
! Avoid extreme heat and direct sunlight.
! Only use rechargeable NiMH AAA batteries! Using unsuitable battery types poses an
explosion hazard!
• Technology: Analogue
• Transmitter: Power supply with mains
adaptor or optionally with AAA NiMH
power pack (not included in the scope of
delivery)
• Receiver: Power supply with mains
adaptor or optionally with 3 AAA NiMH
batteries (included in the deliverables)
• Input: 100 – 220V 50Hz 0.15 A max.

Safety instructions regarding installation

• Output: 6V / 300mA max.
• transmitter power: TX 50 mA , RX 130 mA
• frequency: 864 MHz
• range: 400 m
• cable length: approx. 1.80 m
• working temperature: 10°C - 40°C
• storage temperature: 0°C - 55°C
• standards: EN 300 220-1, EN 301 489-1

Technical specification

and EN 301 489-3
GB
15