Hoover DYM 893/T Mode D'emploi page 34

If it you need to move the machi-
ne after removing the packaging,
do not try to lift it by the bottom of
the door.
Open the door slightly and lift the
machine by holding on the top.
For the installation of built-in
appliances, please refer to the
specific chapter or to the instruc-
tions enclosed with the booklet.
INSTALLATION IN FITTED
KITCHENS
Fitting between existing cabinets
The height of the dishwasher, 85 cm, has
been designed in order to allow the
machine to be fitted between existing
cabinets of the same height in modern
fitted kitchens. The feet can be adjusted
so that correct height is reached.
The laminated top of the machine does
not require any particular care since it is
heatproof, scratchproof and stainproof
(fig. 5).
5
Underneath existing work top
(when fitting beneath a work top)
6 a
b
34
Appliance complies
European Directives:
2006/95/EC (LVD);
2004/108/EC (EMC);
2009/125/EC (ErP);
2011/65/EU (RoHS)
and subsequent amendments
In most modern fitted kitchens there is
only one single work top under which
cabinets and electrical appliances are
fitted. In this case remove the work top
of the dishwasher by unscrewing the
screws under the rear edge of the top
(fig. 6a).
IMPORTANT
After removing the work top, the
screws MUST BE screwed again
under the rear edge of the top
(fig. 6b).
The height will then be reduced to 82 cm,
as scheduled by the International
Regulations (ISO) and the dishwasher
will fit perfectly under the kitchen
working top (fig. 7).
7
a
b
with
598
556/573