Toto B Série Manuel D'installation Et D'utilisation page 4

For Ceramic Tile:
• Drill 1/4" pilot holes a minimum of 1-1/4" deep at each marked location.
• Insert anchors until they are flush with the face of the finished wall.
• Place the mounting bracket over the anchors, insert the screws and
tighten to secure them.
NOTE: If the wall stud is drilled, use a screw instead of an anchor for
mounting.
For Wooden Stud or Stringer:
• Drill 1/8" pilot holes.
• Place the mounting bracket, then insert the screw into the pilot hole and
tighten to secure it.
1. Place the product over the mounting bracket and tighten the set
screw(s) with the hex wrench.
Anchors
Screws
Hex
Key
INSTALLATION PROCEDURE
Mounting
Bracket
Paper
Holder
4
Towel Bar
Double
Robe Hook
Towel
Ring