Important Safety Instructions; Installation; Power Supply - Canon imageRUNNER 2202 Guide Rapide

Important Safety Instructions

Please read these "Important Safety Instructions"
thoroughly before operating the machine. As these
instructions are intended to prevent injury to the
user or other persons or destruction of property,
always pay attention to these instructions. Also,
since it may result in unexpected accidents or
injuries, do not perform any operation unless
otherwise specified in the manual. Improper
operation or use of this machine could result in
personal injury and/or damage requiring extensive
repair that may not be covered under your Limited
Warranty.

Installation

WARNING
• Never block the ventilation slots and louvers on the
machine. These openings are provided for proper
ventilation of working parts inside the machine.
Blocking these openings can cause the machine
to overheat. Never place the machine on a soft
surface, such as a sofa or rug.
• Do not install the machine in the following
locations:
- A damp or dusty location
- A location near water faucets or water
- A location exposed to direct sunlight
- A location subject to high temperatures
- A location near open flames
• Do not install the machine near alcohol, paint
thinner, or other flammable substances. If
flammable substances come into contact with
electrical parts inside the machine, it may result in a
fire or electrical shock.
• Do not place the following items on the machine. If
these items come into contact with a high-voltage
area inside the machine, it may result in a fire or
electrical shock. If these items are dropped or
spilled inside the machine, immediately turn OFF
the main power switch, and disconnect the power
cord from the power outlet. Then, contact your local
authorized Canon dealer.
- Necklaces and other metal objects
- Cups, vases, flowerpots, and other containers filled
with water or liquids
CAUTION
Do not install the machine in unstable locations, such
as unsteady platforms or inclined floors, or in locations
subject to excessive vibrations, as this may cause the
machine to fall or tip over, resulting in personal injury.

Power Supply

WARNING
• Do not damage or modify the power cord. Also,
do not place heavy objects on the power cord, or
pull on or excessively bend it, as this could cause
electrical damage and result in a fire or electrical
shock.
• Keep the power cord away from a heat source;
failure to do this may cause the power cord coating
to melt, resulting in a fire or electrical shock.
• Do not connect or disconnect the power cord with
wet hands, as this may result in electrical shock.
• Do not connect the power cord to a multiplug
power strip, as this may cause a fire or electrical
shock.
• Do not bundle up or tie the power cord in a knot, as
this may result in a fire or electrical shock.
• Insert the power plug completely into the power
outlet, as failure to do so may result in a fire or
electrical shock.
• Do not use power cords other than the power cord
provided, as this may result in a fire or electrical
shock.
• As a general rule, do not use extension cords. Using
an extension cord may result in a fire or electrical
shock.
• Do not use power supplies with voltages other than
those specified herein, as this may result in a fire or
electrical shock.
• Always grasp the power plug when disconnecting
the power cord. Pulling on the power cord may
expose or snap the core wire, or otherwise damage
the power cord. If the power cord is damaged, this
could cause current to leak, resulting in a fire or
electrical shock.
Important Safety Instructions
47