Select A Safe Power Supply; Moving The Machine; Provide Adequate Installation Space; Handling Precautions - Canon imageRUNNER 2202 Guide Rapide

• Avoid installing the machine near televisions, radios,
or similar electronic equipment.
The machine might interfere with sound and picture
signal reception.
Insert the power plug into a dedicated power outlet,
and maintain as much space as possible between the
machine and other electronic equipment.
• Avoid installing the machine at high altitudes of about
3,000 metres above sea level, or higher.
Machines with a hard disk may not operate properly
when used at high altitudes of about 3,000 metres
above sea level, or higher.

Select a Safe Power Supply

• Plug the machine into a 220 - 240 V AC outlet.
• Make sure that the power supply for the machine is
safe, and has a steady voltage.
• Do not connect other electrical equipment to
the same power outlet to which the machine is
connected.
• Do not connect the power cord to a multiplug power
strip, as this may cause a fire or electrical shock.
• The power cord may become damaged if it is stepped
on, affixed with staples, or if heavy objects are placed
on it. Continued use of a damaged power cord can
lead to an accident, such as a fire or electrical shock.
• The power cord should not be taut, as this may lead
to a loose connection and cause overheating, which
could result in a fire.
• If excessive stress is applied to the connection part of
the power cord, it may damage the power cord or the
wires inside the machine may disconnect. This could
result in a fire. Avoid the following situations:
- Connecting and disconnecting the power cord
frequently.
- Tripping over the power cord.
- The power cord is bent near the connection part,
and continuous stress is being applied to the power
outlet or the connection part.
- Applying excessive force on the power plug.

Moving the Machine

• If you intend to move
the machine, even to
a location on the same
floor of your building,
contact your local
authorized Canon dealer
beforehand. Do not
attempt to move the machine yourself.

Provide Adequate Installation Space

Provide enough space on each side of the machine for
unrestricted operation.
100 mm or more
533 mm
1,022.9 mm

Handling Precautions

• Do not attempt to
disassemble or modify the
machine.
• Some parts inside the machine are subject to high-
voltages and temperatures. Take adequate precautions
when inspecting the inside of the machine. Do not
carry out any inspections that are not described in the
manuals for this machine.
• Be careful not to spill
liquid or drop any foreign
objects, such as paper
clips or staples inside
the machine. If a foreign
object comes into
contact with electrical
parts inside the machine,
it might cause a short
circuit and result in a fire
or electrical shock.
Installation Location and Handling
1,285 mm
09