Connection With The Mains; Operation; Sound Control Or Auto-Change - EuroLite AC-300 Air-Effect Mode D'emploi

Occupation of the XLR-connection:
If you are using controllers with this occupation, you can connect the DMX-output of the controller directly
with the DMX-input of the first fixture in the DMX-chain. If you wish to connect DMX-controllers with other
XLR-outputs, you need to use adapter-cables.
Building a serial DMX-chain:
Connect the DMX-output of the first fixture in the DMX-chain with the DMX-input of the next fixture. Always
connect one output with the input of the next fixture until all fixtures are connected.
Caution: At the last fixture, the DMX-cable has to be terminated with a terminator. Solder a 120
between Signal (–) and Signal (+) into a 3-pin XLR-plug and plug it in the DMX-output of the last fixture.

Connection with the mains

Connect the device to the mains with the power-plug.
The occupation of the connection-cables is as follows:
Cable Pin
Brown Live
Blue Neutral
Yellow/Green Earth
The earth has to be connected!
If the device will be directly connected with the local power supply network, a disconnection switch with a
minimum opening of 3 mm at every pole has to be included in the permanent electrical installation.
Lighting effects must not be connected to dimming-packs.

OPERATION

Before starting operation make sure that the cloth cannot be drawn into the intake of the ventilation fan.
After you connected the effect to the mains, the AC-300 DMX LED/RGB Air Effect starts running.

Sound Control or Auto-Change

In order to select Sound Control or Auto-Change, first set all dipswitches to OFF.
Select the desired mode via the slide-switch.
International
L
N
19/41
Ω
resistor
51116120_V_1_1.DOC