Inventum IKI9040 Manuel D'utilisation page 31

INSTALLING THE APPLIANCE
Preliminary requirements
1. Make sure that the installation surface is prepared according to the correct dimensions.
2. Make sure that the ventilation openings are made.
Procedure
1. Remove any dirt from the worktop.
2. Apply a sealant to the edges of a wooden or plastic worktop to prevent damage as a result of moisture.
3. Put the appliance head down on the worktop.
4. Install the fastening brackets to the appliance. Use the screws.
5. Put the appliance in the opening of the worktop.
6. Connect the appliance to the mains supply.
After connecting the display lights up for a short time. The appliance is ready for use.
INSTALLING THE FINISHING
1. Remove the protective film (B) from the finishing (A).
2. Put the finishing around the appliance. Make sure that there is a distance of 2 mm between the appliance and
the seal.
INSTALLING THE DECORATION STRIPS
The packaging includes two stainless steel decoration strips.
Note:
The decoration strips cannot be removed once attached to the induction hob.
1. Attach the decoration strips to the sides of the induction hob.
SETTING THE POWER MANAGEMENT
Use the power management mode to set the total maximum power of the appliance.
Note:
As a default, the appliance is set to 7.4 kW. You can change the power management value to 7.4 kW
(C00) or 10.1 kW (C01).
Note:
Setting the power management must be done within 2 minutes after connecting the appliance.
Warning:
Use a mains supply cable suitable for 10.1 kW when you change the configuration to this setting.
1. Connect the appliance.
2. Make sure that all cooking zones are off.
3. Touch and hold the pause button.
4. Touch and hold the memory button for 2 seconds.
You will hear a single sound signal. When you hear a double sound signal, there is an error. Repeat step 3.
5. Touch the up button.
You will hear a single sound signal. Release all the buttons. When you hear a double sound signal, there is an
error. Repeat step 3.
6. The left display shows C00/C01. Touch the upper left selection/timer button to change the configuration to C01/
C00.
(Figure 13)
• 31
EN