Technical Description - Nordica Inserto 50 Crystal Manuel Utilisateur

TECHNICAL DESCRIPTION

DEfINITION: product according to EN 13229 THE APPLIANCE wORkS AS AN INTERmITTENT OPERATINg APPLIANCE.
the devices La nordica are suitabLe to heat Living spaces for some periods. as fueL, wood Logs are used.
the appliance is made up of a steel chamber completely soldered and hermetic. the hearth is coated by single cast-iron sheets and refractory
plates (nordiKer).
the appLiances are equipped with an integrated air circuit for the recovery of the heat made up of a gaLvanized steeL
carter externaL to the heating body.
inside the hearth there are a grate holder and the related grating, both made of very thick cast-iron and easily extractable.
the insert is equipped with a sight door with ceramic glass (resistant up to 700°c). this allows a charming sight on burning flames. moreover,
in this way, any possible leak of sparks and smoke is avoided. under the hearth grating there is a easily extractable ash drawer.
ACCESSORIES
inserto 50 crystal
inserto 50v crystal bii
inserto 50v p30 crystal
inserto 70 crystal
inserto 80 crystal EVO 2.0
inserto 80 crystal PRS
inserto 100 crystal
the heating of the room occurs:
a) by CONVECTION: the passage of air through the coating and the covering hood releases heat in the room.
b) by RADIATION: through the sight glass and the steel body, heat is radiated into the room.
the device is equipped with registers of primary and secondary air, with which it is possibLe to adjust the combustion
air.
1A - PRImARY AIR register
(Picture
with the air register located under the door of the hearth (on the left), it is possible to adjust the air flow through the ash drawer and the
grating in direction of the fuel. the primary air is necessary for the combustion process during the ignition. in order to open the passage of
primary air the lever should be completely pulled.
the ash drawer has to be emptied regularly, so that ash cannot hinder the intake of primary air for the combustion. primary air is also
necessary to keep fire live.
during the combustion of wood, the primary air register must be opened onLy a few, since otherwise the wood
burns quicKLy and the device can overheat (see chapter normaL operation).
2A - SECONDARY AIR register
under the door of the hearth (on the right) there is the secondary air register.
this register must be opened (and therefore the lever completely pushed), in detail, for the combustion of wood, so that unburnt carbon
can be subject to a post-combustion, increasing the yield and assuring the cleaning of the glass (see chapter normaL operation). It is
possible to get the air SECONDARY directly from outside through a flexible tube (fireproof not furnished
THE ADjuSTmENT Of THE REgISTERS necessary to reach the RATED CALORIfIC YIELD is the following one:
hourly consumption
( kg/h )
PRImARY AIR
SECONDARY AIR
TERTIARY AIR
IT IS POSSIBLE TO gET THE AIR SECONDARY DIRECTLY fROm OuTSIDE through a fLexibLe tube (fireproof not
furnished PICTuRE 11
26
POKER
series
series
series
series
series
series
series
* see instructions manual connection and maintenance of ventiLation optionaL.
8)
(Picture 8)
INSERTO INSERTO
50 Crystal 50v Crystal
BII
1,8 2,4
cLosed cLosed
opened opened
pre- pre-
adjusted adjusted
ref A).
Ventilation KIT 1318000
GLOVE
series
series
series
* OPTIONAL
series
* OPTIONAL
series
* OPTIONAL
series
* OPTIONAL
series
INSERTO INSERTO
50v p30 70 Crystal
Crystal
1,7 2,7
cLosed cLosed
opened opened
pre- pre-
adjusted adjusted
ENGLISH
SECONDARY air KIT
/ 6016040 OPTIONAL
/ 6016040 OPTIONAL
/
6016040 series
6016041 OPTIONAL
6016041 OPTIONAL
6016041 OPTIONAL
6016041 OPTIONAL
Picture 11
inserto inserto
80 cry EVO 80 cry PRS
2.0
2,1 2,2
cLosed cLosed
opened opened
pre- pre-
adjusted adjusted
ref A).
INSERTO
100 Crystal
2,8
cLosed
opened
no