deville C07708 Notice D'emploi page 18

At the time of duct cleaning, the following operations must be carried out :
- Dismount the deflector (Fig. 6) and (Fig. 7) :
. Dismount the deflector (lift the deflector
remove it 5 through the right-hand side).
- Dismount the rear plate of the hearth, the two lateral hearth plates, the hearth grid and the duct pipe.
(Assembling the deflector : perform the disassembly operation in the reverse order).
- Check thoroughly the state of the appliance and particularly the elements ensuring sealing : locking joints and
devices, supporting parts (door, frame).
- Check the state of the smoke duct and connecting duct : all the connections must show proper mechanical
resistance and sealing.
- Clean the appliance using a brush and a vacuum cleaner.
In the event of an anomaly : have the appliance repaired or the installation performed by a qualified professional.
After a long off-period :
- Check that nothing obstructs any pipes before using the stove again.
CURRENT MAINTENANCE
- Clean the window using a damp cloth and ash. If required, use an adapted household cleaning product by
observing the instructions of the operation manuals. Wait for the appliance to be completely cooled before
proceeding with this operation.
- Clean regularly the ventilation guides (Fig. 8) :
. Using the tip of a metallic object
which may have formed.
. Using a vacuum cleaner
(Fig. 9).
These particles prevent the forming of the secondary air layer which protects the window from direct contact
with the smoke and completes the combustion of the wood (Fig. 9).
. These operations must be performed whenever the window is dirty and systematically following the total
extinction of the hearth.
For C07787 :
•
Check the efficiency of the door latch and, if required, make the following adjustments (Fig. 10) :
To harden door closure :
-
Successively loosen screw
.
. Turn both screws ¼ turn and repeat the operation as required.
NOTE : This operation increases pressure on the hearth door's sealing gasket.
To soften door closure:
-
Successively loosen screw
.
. Turn both screws ¼ turn and repeat the operation as required.
NOTE : This operation reduces pressure on the hearth door's sealing gasket.
1, move it forward 2, tilt the rear
, scratch the inner edges of the cast iron to remove the soot
, remove the particles and dust trapped between the door and window
and tighten screw
and tighten screw
18
.
.
3, lower it 4 and