All operating elements and connections described
GB
can be found on the fold-out page 3.
1
Operating Elements and Connections
1.1 Camera
1 Key for setting the focus
2 Lens, can be turned with the key (1) for focus set-
ting
3 Camera support
4 Transmitting antenna
5 Low voltage jack for connection of the supplied
charger
6 Charging LED "Charge", lights up when the internal
rechargeable battery is being charged
7 "Power" LED
8 Channel switch and on/off switch
19 Low voltage plug of the 5 V charger
1.2 Receiver
10 Antenna connection (SMA jack)
11 Button for manual channel selection
12 LEDs to indicate the channel received
13 Plug-in power supply unit (8 V ) for the receiver
14 DIP switches for the operating mode
Switches 1 – 4: The automatic channel selection will
switch between the channels of which the switches
8
are set to ON; the other channels will be skipped.
Switch M/L: To switch between manual channel
selection (M) and automatic channel selection (L)
15 Connection jack DC8V for the plug-in power supply
unit provided (13)
16 Jack A/V for the audio/video output
17 Reception antenna
2
Safety Notes
The units (camera, receiver, charger, and plug-in
power supply unit) correspond to all required directives
of the EU and are therefore marked with
WARNING The charger and the plug-in power supply
unit are supplied with hazardous mains
voltage (230 V~). Leave servicing to
skilled personnel only. Inexpert handling
may cause an electric shock hazard.
Please observe the following items in any case:
G
The camera must not be operated near cardiac
pacemakers (minimum distance 25 cm) and medical
appliances. The electromagnetic radiation may lead
to interference.
G
The units are suitable for indoor use only. Protect
them against high air humidity, dripping water and
splash water, and extreme temperatures (admissible
ambient temperature range
G
Even if the camera is switched off, the charger con-
.
10 °C to +50 °C).
-