Ferroli OMNIA ST 3.2 Manuel D'installation, D'utilisation Et D'entretien page 75

OMNIA ST 3.2
CAUTION
Ground the unit.
Grounding resistance should be according to local laws and regulations.
Do not connect the ground wire to gas or water pipes, lightning conductors or telephone ground wires.
Incomplete grounding may cause electric shocks.
Gas pipes: Fire or an explosion might occur if the gas leaks.
Water pipes: Hard vinyl tubes are not effective grounds.
Lightning conductors or telephone ground wires: electrical threshold may rise abnormally if struck by a lightning
bolt.
Install the power wire at least 1 meter away from televisions or radios to prevent interference or noise.
(Depending on the radio waves, a distance of 1 meter may not be sufficient to eliminate the noise.)
Do not wash the unit. This may cause electric shocks or fire. The appliance must be installed in accordance with
national wiring regulations. If the supply cord is damaged, it must be replaced by the manufacturer, its service agent
or similarly qualified persons in order to avoid a hazard.
Do not install the unit in the following places:
• Where there is mist of mineral oil, oil spray or vapors. Plastic parts may deteriorate, and cause them to come
loose or water to leak.
• Where corrosive gases (such as sulphurous acid gas) are produced. Where corrosion of copper pipes or solde-
red parts may cause refrigerant to leak.
• Where there is machinery which emits electromagnetic waves. Electromagnetic waves can disturb the control
system and cause equipment malfunction.
• Where flammable gases may leak, where carbon fiber or ignitable dust is suspended in the air or where volatile
flammables such as paint thinner or gasoline are handled. These types of gases might cause a fire.
• Where the air contains high levels of salt such as near the ocean.
• Where voltage fluctuates a lot, such as in factories.
• In vehicles or vessels.
• Where acidic or alkaline vapors are present.
This appliance can be used by children 8 years old and above and persons with reduced physical, sensory or mental
capabilities or lack of experience and knowledge if they are supervised or given instruction on using the unit in a
safe manner and understand the hazards involved. Children should not play with the unit. Cleaning and user main-
tenance should not be done by children without supervision.
Children should be supervised to ensure that they do not play with the appliance.
If the supply cord is damaged, it must be replaced by the manufacturer or its service agent or a similarly qualified
person.
DISPOSAL: Do not dispose this product as unsorted municipal waste. Collection of such waste separately for
special treatment is necessary. Do not dispose of electrical appliances as municipal waste, use separate collection
facilities. Contact your local government for information regarding the collection systems available. If electrical ap-
pliances are disposed of in landfills or dumps, hazardous substance can leak into the groundwater and get into the
food chain, damaging your health and well-being.
The wiring must be performed by professional technicians in accordance with national wiring regulation and this
circuit diagram. An all-pole disconnection device which has at least 3mm separation distance in all pole and a resi-
dual current device(RCD) with the rating not exceeding 30mA shall be incorporated in the fixed wiring according to
the national rule.
Confirm the safety of the installation area (walls, floors, etc. ) without hidden dangers such as water, electricity, and
gas. Before wiring/pipes.
Before installation , check whether the user's power supply meets the electrical installation requirements of unit
(including reliable grounding , leakage , and wire diameter electrical load, etc. ). If the electrical installation require-
ments of the product are not met, the installation of the product is prohibited until the product is rectified.
When installing multiple air conditioners in a centralized manner, please confirm the load balance of the three-phase
power supply, and multiple units are prevented from being assembled into the same phase of the three-phase power
supply.
Product installation should be fixed firmly, Take reinforcement measures, when necessary.
Cod. 3541V991 - Rev. 01 - 10/2021
75
EN