Operation; Batteries; Measuring Weight Only; Setting User Data - Beurer BF 195 LE Mode D'emploi

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 16
• Ages 10 to 80 years and height settings from 100 to 220 cm (3-03" to 7-03") can be preset. Load capacity: max.
180 kg (396 lb, 28 st). Result in steps of 100g (0.2 lb, 1/4 st). Measurements of body fat, body water and muscle
density in steps of 0.1%.
• When supplied to the customer, the scale is set to weigh and measure in "kg" and "cm".
On the back of the scale, there is a toggle button where you can select "pounds" (lb) and
"stones" (st).
• Place the scale on a firm level floor; a firm floor covering is required for correct measurement.
• The scale should be cleaned occasionally with a damp cloth. Do not use abrasive deter-
gents and never immerse the scale in water.
• Protect the scale against hard knocks, moisture, dust, chemicals, major temperature fluc-
tuations and heat sources which are too close (stove, heating radiator).
• Repairs may only be carried out by customer service or authorized dealers. Before submitting any complaint,
first check the batteries and replace them if necessary.
• For environmental reasons, do not dispose of the device in the household waste at the end of its useful life.
Dispose of the unit at a suitable local collection or recycling point. Dispose of the device in accordance
with EC Directive – WEEE (Waste Electrical and Electronic Equipment). If you have any questions, please
contact the local authorities responsible for waste disposal.

2. Operation

2.1 Batteries

If present, pull the battery insulating strip off the battery compartment cover or remove the bat-
tery's protective film and insert the battery according to the polarity. If the scale fails to operate,
remove the battery completely and insert it again. Your scale is equipped with a "replace battery"
indicator. When the scale is operated with a battery which is too weak, "Lo" appears in the display
field and the scale automatically switches off. In this case the batteries must be replaced (2x CR
2032). The empty, completely flat batteries must be disposed of through specially designated
collection boxes, recycling points or electronics retailers. You are legally required to dispose of the
batteries.
The codes below are printed on batteries containing harmful substances:
Pb = Battery contains lead,
Cd = Battery contains cadmium,
Hg = Battery contains mercury.

2.2 Measuring weight only

Step onto the scale. Stand still with your weight distributed equally on both feet. The scale begins to take measure-
ments straight away. If the display appears continuously, the measurement has finished.
If you step off the weighing area, the scale switches off after a few seconds.

2.3 Setting user data

To measure your body fat percentage and other physical data, you must enter your personal user para meters.
The scale has 10 memory positions in which you and other members of your family can save and recall personal
settings. Please note that the memory begins with 1.
Switch on the scale (tap the standing surface). Wait until the display shows "0.0".
Then press "SET". The first memory position will appear flashing on the display. Now you can enter the following
settings:
Memory position
Age
Body size
Sex
Degree of activity
– Modifying values: Press
– Confirming entries: Press the "SET" button.
– After the values have been set and displayed again, "0.0" appears on the display together with the symbol for
the selected gender
1 to 10
10 to 80 years
100 to 220 cm (3'-03" to 7'-03")
male (
), female (
)
1 to 5
or
or press and hold for more rapid progress.
/
.
11

Publicité

Table des Matières
loading

Table des Matières