9. Smartphone holder
Attach the smartphone holder to the eyepiece.
The suction cups must be clean and free from dust and dirt. A slight moistening is
helpful. Now press your smartphone on the retaining plate and make sure that it
is properly secured. As a backup, you should secure it with the enclosed rubber
strap. Smartphones with a rough surface will not hold as good as smartphones with
a smooth surface.
Now start the Camera app.
The camera needs to rest just above the eyepiece. Center the smartphone exactly
over the eyepiece, so the image can be seen precisely centered on your screen.
In some cases you need to adjust with the zoom function to display the image
fullscreen. A light shading at the edges is possible. Take the smartphone carefully
off the holder after use.
NOTE:
Make sure that the smartphone can not slip out of the holder.
Bresser GmbH assumes no liability for any damages caused by a dropped smart-
phone.
NOTE:
Do not use any cleaning fluid to avoid damaging the electronics.
Clean the lenses eyepieces and lenses only with a soft, lint-free cloth, like a mi-
crofibre cloth.
NOTE:
Do not apply excess pressure to the cloth so as to avoid scrat-
ching the lenses.
To remove more stubborn dirt, moisten the cleaning cloth with an eyeglass-clean-
ing solution and wipe the lenses gently. Protect the device from dust and moisture.
After use, particularly in high humidity, let the device acclimatize for a short period
of time, so that the residual moisture can dissipate before storing.
Troubleshooting
Problem
Solution
No picture visible
• Switch light on.
• Put condenser lens in place.
• Adjust focus.
Magnification table
Eyepiece
Objective
Magnification
10X
4X
10X
10X
100X
10X
40X
400X
16X
4X
16X
10X
160X
16X
40X
640X
Disposal
Dispose of the packaging materials properly, according to their type, such
as paper or cardboard. Contact your local waste-disposal service or envi-
ronmental authority for information on the proper disposal.
Do not dispose of electronic devices in the household garbage.
As per the Directive 2002/96/EC of the European Parliament on waste
electrical and electronic equipment and its adaptation into German law,
used electronic devices must be collected separately and recycled in an
environmentally friendly manner. Empty old batteries must be disposed of at
battery collection points by the consumer. You can find out more information
about the disposal of devices or batteries produced after 1 June 2006 from
your local waste disposal service or environmental authority.
Declaration of Conformity
Product Type:
Microscope
Product Name:
Article No.:
90-39001
Bresser GmbH has issued a 'Declaration of Conformity' in accordance with appli-
cable guidelines and corresponding standards. This can be viewed any time upon
request.
with Barlow lens
40X
80X
200X
800X
64X
128X
320X
1280X
Microscope 40X-1280X
EN
15