Sanding Cuts And Sandpaper - Clarke American Sanders Super 7R Manuel De L'utilisateur

ENGLISH
EN
revised 9/12

SANDING CUTS AND SANDPAPER

Initial Cut
The purpose of the initial cut is to remove old fi nish and gross imperfections on the fl oor surface. A coarse abrasive should be used.
If glazing, loading, or burning takes place immediately into an initial cut, select a coarser abrasive. If this should occur during an initial
cut, the abrasive has dulled and must be replaced.
Final Cuts
The purpose of a fi nishing cut is to remove the scratches produced during the initial cut. Use a fi ne (60 - 80 grit) grain abrasive.
If the surface remains rough after a fi nishing cut, it may be necessary to use an even fi ner grain of abrasive (80 - 100 grit). Care
should be taken in selecting the grit size of the abrasive. A very fi ne grain will close the pores on a wood fl oor making admission of a
stain diffi cult.
American Sanders Operator's Manual (EN) - Super 7R FORM NO 70402B - 7 -
Clarke ®