Lubrication - Heiniger XPERT Mode D'emploi

1,5 – 2 mm
Fig. 10
NOTE!
Only work with sharp blades, replace blunt or defective blades
X X
without teeth. The correct resharpening of blades is only to do
by special machines or by a specialist. In that case, contact
your service centre.
6.6

Lubrication

Fig. 11
CAUTION!
POSSIBLE DAMAGE TO THE CLIPPER!
Insufficient oiling of the clipping head will lead to warming and will
shorten the life of the clippers and its blades.
Oil the clipping blades adequately during the clipping session,
X X
at least once every 15 minutes, so that they do not run dry.
Only use the special oil supplied or a paraffin oil conforming to
X X
the ISO VG 15 specification.
NOTE!
The provided oil is non-toxic and produces no irritation on con-
X X
tact with the skin or the mucous membranes. This paraffin oil
degrades to some 20% after 21 days (CEL-L-33-T-82).
14
Install the new comb plate. Align it so
X X
that the ground surface of the comb
plate protrudes by approx. 1.5 - 2 mm
above the point of the upper blade.
Tighten the comb plate screws.
X X
To ensure a well-clipped animal and to
increase the life of the clipper including
the shearing head, it is necessary to ap-
ply a thin coat of oil between the upper
blade and comb plate. All other moving
parts of the clipping head must also be
lubricated.
Apply some drops of oil on to the
X X
clipping blades and into the lubrica-
tion opening.
Instruction Manual / Xpert 2-Speed sheep clipper