FCC INFORMATION (FOR US CUSTOMERS)
1. PRODUCT
This product complies with Part 15 of the FCC Rules. Operation
is subject to the following two conditions: (1) This device may
not cause harmful interference, and (2) this device must accept
any interference received, including interference that may
cause undesired operation.
2. IMPORTANT NOTICE:
DO NOT MODIFY THIS PRODUCT
This product, when installed as indicated in the instructions
contained in this manual, meets FCC requirements. Modification
not expressly approved by ARCAM may void your authority,
granted by the FCC, to use the product.
3. NOTE
This product has been tested and found to comply with the
limits for a Class B digital device, persuant to Part 15 of the
FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential
installation.
This product generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with
INDUSTRY CANADA INFORMATION (FOR CANADIAN
CUSTOMERS)
This Class B digital apparatus complies with canadian ICES-003
1. " This device complies with Industry Canada licence-exempt
RSS standard(s). Operation is subject to the following two
conditions: (1) this device may not cause interference, and (2)
this device must accept any interference, including interference
that may cause undesired operation of the device.
Le présent appareil est conforme aux CNR d'Industrie
Canada applicables aux appareils radio exempts de licence.
L'exploitation est autorisée aux deux conditions suivantes : (1)
l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur
de l'appareil doit accepter tout brouillage radioélectrique subi,
même si le brouillage est susceptible d'en compromettre le
fonctionnement"
2. " This radio transmitter 10792A -DNW101020-00 has been
approved by Industry Canada to operate with the antenna
types listed below with the maximum permissible gain and
required antenna impedance for each antenna type indicated.
Antenna types not included in this list, having a gain greater
than the maximum gain indicated for that type, are strictly
prohibited for use with this device.
IMPORTANT ANTENNA INFORMATION
The rBlink is only designed to operate with the supplied
antenna. Any other antenna are strictly prohibited for use with
the rBlink.
the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that
interference will not occur in a particular installation. If this
product does cause harmful interference to radio or television
reception, which can be determined by turning the product
OFF and ON, the user is encouraged to try to correct the
interference by one or more of the following measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and
receiver.
•
Connect the product into an outlet on a circuit different
from that to which the receiver is connected.
•
Consult the local retailer authorized to distribute this
type of product or an experienced radio/TV technician
for help.
This equipment complies with FCC RF radiation exposure limits
set forth for an uncontrolled environment. This equipment
should be installed and operated with minimum distance 20
cm between the antenna and your body.
Le présent émetteur radio 10792A -DNW101020-00 a été
approuvé par Industrie Canada pour fonctionner avec les types
d'antenne énumérés ci-dessous et ayant un gain admissible
maximal et l'impédance requise pour chaque type d'antenne.
Les types d'antenne non inclus dans cette liste, ou dont le
gain est supérieur au gain maximal indiqué, sont strictement
interdits pour l'exploitation de l'émetteur. "
{Wanshih WSS002, Antenna Gain +2dBi}
3. "This equipment complies with IC RSS102 radiation
exposure limits set forth for an uncontrolled environment. This
equipment should be installed and operated with minimum
distance 20 cm between the antenna and your body.
Cet équipement est conforme aux limites IC RSS102
d'exposition aux rayonnements définies pour un
environnement non contrôlé. Cet équipement doit être installé
et utilisé à distance minimale de 20 cm entre l'antenne et votre
corps. "
13