Skandika Fitness VIBRATION PLATE 1400 Instructions De Montage Et Mode D'emploi page 17

Press again, the screen will show
to enter the values in the same way as already done for step 1. Proceed in this way until step 12 and
then press - "U1" will now stop ashing.
If want to revise the before set program, press
on the left or right side to adjust the levels accordingly. Press
Note
a. "U2" and "U3" can be programmed in the same way as "U1".
b. Any program will repeat automatically until the workout time is nished.
c. Press to stop workout anytime. Computer will enter "MANUAL" mode.
d. To interrupt programming, press
e. During "P1"/"P2"/"P3"/"U1"/"U2"/"U3" modes, only
5. BMI function
In standby mode, press
Press to select gender and
cm.
The screen will show "
BMI will be shown.
and the second step programming starts. You need
.
. Screen will show BMI. " " is ashing (" "= male," " = female).
to con rm, followed by your weight in kg and your height in
". Now put your ngers onto the two sensors
until the desired step is reached. Press
to run the program.
button is active.
and your measured
17