Cleaning; Troubleshooting - Siemens MQ955 Série Mode D'emploi

en

Cleaning

Base unit with high-speed hand
blender
The high-speed hand blender is suitable for
blending mayonnaise (only whole eggs),
sauces, mixed drinks, baby food, cooked
fruit and vegetables. For puréeing soups.
Use the universal cutter for cutting/chopping
raw food (onions, garlic, herbs).
X Fig. C
1. Push up the lock on the rear aperture
until it locks into position.
2. Insert the high-speed hand blender and
lock into position.
3. Place the high-speed hand blender in
the receptacle. To prevent food from
splashing, immerse the high-speed
hand blender in the food before switch-
ing on the appliance.
Warning!
Do not immerse the appliance in liquid
above the joint between the high-speed
hand blender and base unit.
4. Insert the mains plug. Turn the switch to
setting M and hold.
5. Process the ingredients as required.
Tip: The high-speed hand blender works
better if there is some liquid between the
ingredients being processed.
6. Release the switch.
Tip: To make cleaning the high-speed hand
blender easier, after use place it in a recep-
tacle containing clean water and briefly turn
the switch to setting M several times.
7. Pull out the mains plug.
8. Remove the high-speed hand blender
by simultaneously pressing both release
buttons.
9. Close the lock on the rear aperture.
16
Cleaning
The appliance and the accessories used
must be thoroughly cleaned after each use.
X Table E
W Risk of electric shock!
Disconnect the mains plug before
cleaning.
Warning!
■ Do not use cleaning agents containing
alcohol or spirits.
■ Do not use sharp, pointed or metal
objects.
■ Do not use abrasive cloths or cleaning
agents.
■ Clean the base unit with a soft, damp
cloth and then rub dry.
■ Clean the high-speed hand blender
in the dishwasher or with a brush under
running water. Never clean blades with
bare hands. Leave the high-speed hand
blender to dry in an upright position
(blender foot blade at top) so that any
water inside can run out. X Fig. F
X Fig. G
■ The power cord can be wound up for
storage of the appliance.

Troubleshooting

Problem:
Switch cannot be moved to Levels 1 to 5.
Remedy:
When the rear aperture is open, selector
switch will not function between Levels 1
and 5. The lock must be completely closed.