Maytag W10649235C Guide D'utilisation Et D'entretien page 11

12.
Touch and hold START to begin
wash cycle
Touch and hold START to start the wash cycle. To pause
a cycle in progress, touch START once, then touch and
hold again to continue the cycle. To cancel a cycle, touch
POWER/CANCEL.
Once you touch and hold START, you will hear the door lock,
unlock, and lock again. The washer door will remain locked during
the wash cycle.
Unlocking the door to add garments:
If you need to open the door to add 1 or 2
missed garments, you may do so while the
"Add a Garment" light is lit.
Touch START once; the door will unlock
once the washer movement has stopped.
This may take several minutes. Then close
door and touch and hold START again to
restart the cycle.
13.
Remove garments promptly
after cycle is finished
Promptly remove garments after cycle has
completed to avoid odor and rusting of metal
objects on garments. When unloading garments,
pull back the door seal and check for small items
between the tub and the washer drum.
NOTES:
n A small amount of water may remain in the dispensers after the
wash cycle is complete. This is normal.
n This washer has a tight seal to avoid water leaks. To avoid odors,
leave the door open to allow the washer to dry between uses.
11