Installation Procedure - Toto Silas TB210DD Manuel D'installation Et D'utilisation

INSTALLATION PROCEDURE - SPOUT
1. Confirm that the valves have been installed properly. See
the TBMT installation manual for further information.
2. Remove plug from outlet. (Figure 1).
3. Orient spout assembly as shown and lower onto exposed
portion of diverter valve. Fasten spout to valve with
provided set screw. Tighten with hex key as needed.
(Figure 2).
Figure 1
INSTALLATION PROCEDURE - HANDLES
1. Orient handle assembly and lower
onto the exposed portion of valve
until engaged. Rotate the base
(dome) of the handle assembly to
fasten it to the valve.
2. Repeat for other handle assembly.
NOTE: If handles do not line up
exactly as desired, remove handle
from valve and reinstall one (1)
notch over (on valve).
Fine adjustment may be done
by slightly rotating valve from
underneath installed surface.
Remove plug
Spout Assembly
Figure 2
Hot
4
Set Screw
Handle Assembly
Cold