Service Schedule; Handover Confirmation; Service Confirmation - Viking GE 103 Manuel D'utilisation

– Feed chute not properly closed - safety
cut-off switch actuated (safety interlock)
– Blade disc blocked
– Locking device is not reset
Remedy:
– Allow machine to cool down (
– Check power cable and fuse
( 10.1)
– Check cable, plug, connector and
switch and replace if necessary (by
electrician) ( 10.1)
– Replace fuse
– Close feed chute properly and tighten
screws ( 11.3)
– Remove feed chute and remove
shredder deposits from the housing
(Important: disconnect the power cable)
( 11.2)
– Reset locking device (
Fault:
Frequently tripped mains fuse
Possible cause:
– Unsuitable electric cable
– Power overload
– Machine overloaded
Remedy:
– Use suitable electric cable (
– Connect the machine to another circuit
– Reduce quantity of shredding material;
reverse, re-sharpen or replace the
shredding blades (
Fault:
Reduced shredding performance
Possible cause:
– Blunt blades
Remedy:
– Reverse, re-sharpen or replace
shredding blades (
40

20. Service schedule

20.1 Handover confirmation

8.6)
11.4)

20.2 Service confirmation

Please hand this instruction manual
10.1)
to your VIKING specialist dealer in
the case of maintenance work.
He will confirm the service operations
performed in the pre-printed boxes.
11.5)
Service performed on
Next service date
11.5)
24
0478 201 9910 D - EN