Standard Equipment; Preparing The Machine For; Attaching Wheel Axle And Wheels; Installing The Ejection Chute - Viking GE 103 Manuel D'utilisation

Risk of injury!
Keep other persons out of
the danger area.
Risk of injury!
Rotating tools.
Keep hands and feet away
from apertures when
machine is running.
Risk of injury!
Switch off the motor and dis-
connect the power cable
from the machine before
working on the cutting tool,
before performing mainte-
nance and cleaning work,
before checking whether the
electric cable is entwined or
damaged and before leaving
the machine unattended.
Wear hearing protection.
Wear safety glasses.
Wear work gloves.
Risk of injury:
Do not climb onto the
machine.
32
Risk of injury:
Never put your hands or any
other part of your body or
clothing into the feed chute
or ejection chute.

6. Standard equipment

Item Designation
A Basic unit with feed chute
B Wheel carrier
C Ejection chute extension
D Discharge flap
E Strip
F Wheel axle
G Wheel
H Wheel cap
I Pin
J Hexagon bolt
M5x40
K Nut M5
L Washer A13
M Quick fastener
N Self-tapping screw
P5 x 40
O Torx screw
P5 x 20
P Torx screw
P5 x 10
Q Combination spanner
•
Instruction manual

7. Preparing the machine for

operation
Risk of injury:
Observe the safety instructions in
the "For your safety" section. (
7.1 Attaching wheel axle and
wheels
2
● Attach the wheel axle (F) to the
Qty.
wheel carrier (B) with the bolts (J) and
1
nuts (K) using the combination
1 spanner (Q) (4 - 6 Nm).
1
● Push the washers (L) and wheels (G)
1
onto the mounted wheel axle.
1
● Attach the wheels to the wheel axle
1
using quick fasteners (M). Quick
fasteners must be pushed onto the
2
wheel axle only to the extent that the
2
wheels can still turn freely once
2
mounted.
2
● Press on the wheel caps (H).
2 Quick fasteners (M) can only be
detached by destroying.
2
2
2

7.2 Installing the ejection chute

extension and chassis

3
● Place basic unit (A) with the
chute facing downwards onto a
2
level, clean surface.
1
● Engage the hooks (1) of the ejection
chute extension (C) into the
1
openings (A) on the rear of the basic
unit and tilt the extension so that the
front part of the basic unit is precisely
inserted in the opening of the ejection
chute extension.
4.)
3
4
5
0478 201 9910 D - EN