Cavist 122 Manuel D'utilisation page 10

2. DESCRIPTION OF APPLIANCE
Model CAVIST122
3. INSTALLATION INSTRUCTIONS
Before using your appliance:
• Remove inner and outer packaging.
•Before connecting the appliance to the electrical socket, leave it in position for 24 hours. This will
reduce the possibility of malfunction of the refrigeration circuit due to transport.
•Clean the inside using a soft cloth and lukewarm water.
Installing your appliance:
• This appliance should be placed in a well ventilated, dry room.
• Position it in a place with sufficient strength to support its weight when loaded. To ensure that it
is level, adjust the height of the feet underneath.
• To get the best from your appliance with the lowest energy consumption, do not place the
appliance close to a heat source (heater, cooker, etc.), do not expose it to direct sunlight, and do
not place it in a room which is too cold.
• Plug the appliance into an exclusively, easily accessible plug socket. Any questions power and
/or grounding should be directed toward a certified electrician or an authorized service centre.
• To prevent the appliance from heating up, ensure adequate ventilation and never block or cover
the Ventilation holes.
Note: Make sure that the socket and ON/OFF switch are easily accessible after the appliance has
been installed.
1 Fan
2 Control panel
3 Shelf
4 Door support
5 Adjustable feet
6 Lower hinge
7 Door glass
8 Handle
9 Door seal
10 Upper hinge