Electrical Information - Vintec A18342801 Guide D'utilisation Et D'entretien

Important Safety Information
6

Electrical Information

• The Wine Cabinet must be plugged
into its own dedicated 115 Volt, 60
Hz., 15 Amp, AC only electrical outlet.
The power cord of the appliance
is equipped with a three-prong
grounding plug for your protection
against electrical shock hazards.
It must be plugged directly into
a properly grounded three prong
receptacle. The receptacle must be
installed in accordance with local
codes and ordinances. Consult a
qualified electrician. Avoid connecting
refrigerator to a Ground Fault
Interruptor (GFI) circuit. Do not use an
extension cord or adapter plug.
• If the power cord is damaged, it
should be replaced by an authorized
service technician to prevent any risk.
• Never unplug the Wine Cabinet by
pulling on the power cord. Always
grip the plug firmly, and pull straight
out from the receptacle to prevent
damaging the power cord.
• Unplug the Wine Cabinet before
cleaning and before replacing a light
bulb to avoid electrical shock.
• Performance may be affected if
the voltage varies by 10% or more.
Operating the Wine Cabinet with
insufficient power can damage the
compressor. Such damage is not
covered under your warranty.
• Do not plug the unit into an electrical
outlet controlled by a wall switch or
pull cord to prevent the Wine Cabinet
from being turned off accidentally.
Grounding type wall receptacle
Power cord with
3-prong grounded plug
Do not, under
any circumstances,
cut, remove,
or bypass the
grounding prong.
This appliance is intended to be used in
household and similar applications such
as:
• Staff kitchen areas in shops, offices
and other working environments
• Farm houses and by clients in hotels,
motels and other residential type
environments
• Bed and breakfast type environments
• Catering and similar non-retail
applications
• The appliance shall not be exposed
to rain
To connect your unit:
1 Locate Power cord box inside unit.
2 Remove Power cord from box and
insert the plug into the electrical box
on the back of the appliance.
3 Connect the plug to electrical source.