Troubleshooting - Vintec A17653101 Guide D'utilisation Et D'entretien

Before You Call for Service
If the unit appears to be malfunctioning,
read through this manual first. If
the problem persists, check the
Troubleshooting Guide below. Locate the
problem in the guide and refer to the cause
and its remedy before calling for service.
The problem may be something very simple
that can be solved without a service call.
Consulting or contracting a qualified service
technician may be necessary.
WARNING
ELECTROCUTION HAZARD
NEVER attempt to repair or perform maintenance on the unit until the main electrical
power has been disconnected.
Problem
Unit not cold
enough.
Adjust
temperatures
(see "Adjusting
the Temperature"
in the "Start-Up
and Temperature
Control" section).
Unit too cold.
Contents of unit
too cold/frozen.
Adjust temperatures
(see "Adjusting
the Temperature"
in the "Start-Up
and Temperature
Control" section).
No interior light.
Light will not go
out when door is
closed.
Possible Cause
• Control set too warm.
• Light staying on.
• Airflow to front grille
blocked.
• Door gasket not
sealing properly.
• Unit is in DEMO
Mode
• Control set too cold.
• Failed LED assembly.
• Light setting is set
to OFF.
• Manual light control
is ON.
• Door switch not
making contact.

Troubleshooting

If Service is Required
Contact the dealer where you purchased
the unit if service is required. State the
model and serial number and explain the
problem. The model and serial number
plate is located on the ceiling of your unit.
If you do not know the name of the selling
dealer or a local service company, you can
check online at www.vintec.com or call
1-800-325-1371.
Remedy
• Adjust temperature
colder. Allow 24 hours for
temperature to stabilize.
• Turn off manual light control.
See "Controls and Settings"
section.
• Airflow must not be obstructed
to front grille. See "Installation"
section.
• Adjust door gasket.
• See "Controls and Settings"
section.
• Adjust temperature
warmer. Allow 24 hours for
temperature to stabilize.
• Contact a qualified Vintec
Service Technician.
• Check light control. See
"Controls and Settings"
section.
• Turn off manual light control.
See "Operation" section.
• Check for proper door
alignment.
19