BH FITNESS G410 Instructions De Montage Et Utilisation page 14

handle of the other hand.
5.- Take the heel piece holding bar
and fit the heel holder bracket (7) along
with the heel piece (31) onto the heel
piece holding bar (9) Fig.8, and
according the detail, steps A and B.
Next, Perform similar assembly to the
heel holder bracket
FITTING THE FOOT SUPPORT.-
6.- Insert the front heel holder (5) on
the front rod (11)
centered and place the caps (26) on
the heel holder (5).
FITTING THE TELESCOPIC
TUBE.-
7.- Once placed the feet support, take
the knob from backrest bracket (30)
and pull it out as instructed in Fig.10.
Then push the spring (18) Fig.10 and
insert the telescopic tube (8) inside the
backrest tube Fig.10 stop pulling the
knob and select the scale height of the
telescopic tube. Make sure you hear a
"CLIP" locking in the corresponding
hole.
Secure by holding it with the knob
(30) as shown
Important: Once you have completed
of the other hand.
Fig.9,place them
in Fig.10,
all of the assembly steps for the
appliance, secure the anti-rollover
strap to the ring on the backrest
support (32)
(10) and the main support (1), Fig 11
and 12. Always set the security tape,
for different angles of the exercise.
Location and placement.-
Exercises should be performed in an
open, well lit place, with more than 4m2
of clear space around the unit.
This inversion table is designed mainly
for home use for performing special
and health checks.
The inversion table has a natural
design for comfortable, safe use.
It is also important to remain relaxed.
It can be rotated to different angles.
Angle positions.-
See end pages.
Do not hesitate to get touch with the
Technical Assistance Service if you
have any queries by phoning customer
services (see last page in manual).
BH RESERVES THE RIGHT TO
MODIFY THE SPECIFICATIONS OF
ITS PRODUCTS WITHOUT PRIOR
NOTICE
14
and on the bed frame