Ryobi A25RT02 Manuel D'utilisation page 7

RESET BUTTON
See Figure 2.
The router table switch is equipped with a reset button that
protects the electronic components of the router table switch
box from overload.
STARTING PIN
When you are unable to use the fence for a guide because
the workpiece is odd-shaped or too small, use the starting
pin for a guide and/or pivot point. Only use piloted cutters
when using the starting pin.
THROAT PLATES
Five throat plates are included with the router table. The
throat plate provides a stable surface around the cutter
and prevents objects from falling through the throat and
damaging the spindle.
VACUUM PORT
The vacuum ports molded into the fence will accept either
a 1-1/4 in. or 2-1/2 in. vacuum attachment.
SWITCH ASSEMBLY
See Figure 3.
This product is equipped with a switch assembly that has a
built-in locking feature. This feature is intended to prevent
unauthorized and possible hazardous use by children and
others.
TO TURN YOUR ROUTER TABLE ON:
 Plug the router into either switch box outlet on the router
table and plug the router table into a 120 volt grounded
outlet.
 With the switch key inserted into the switch, lift the switch
to turn ON ( l ).
NOTE: The router table is equipped with a reset button. See
Figure 2. If, for any reason, the router table will not turn on,
press the reset button and then restart.
TO TURN YOUR ROUTER TABLE OFF:
 Press the switch down to turn OFF ( O ).
TO LOCK YOUR ROUTER TABLE:
 Press the switch down.
 Remove the switch key from the switch and store in a
safe, secure location.
FEATURES
WARNING:
Always remove the switch key when the tool is not in
use and keep it in a safe place. In the event of a power
failure, turn the switch OFF ( O ) and remove the key.
This action will prevent the tool from accidentally starting
when power returns.
WARNING:
ALWAYS make sure your workpiece is not in contact with
the cutter before operating the switch to start the tool.
Failure to heed this warning may cause the workpiece to
be kicked back toward the operator and result in serious
personal injury.
WARNING:
To reduce the risk of accidental starting, ALWAYS make
sure the switch is in the OFF ( O ) position before plugging
tool into the power source.
SWITCH KEY
7
SWITCH
SWITCH
ON
SWITCH IN LOCKED POSITION
OFF
Fig. 3