Ryobi A25RT02 Manuel D'utilisation page 10

ASSEMBLING THE ROUTER TABLE
Assembling the router table involves attaching the switch
box, the under table guards, the legs, the router/insert plate
assembly, the fence assembly, featherboard, throat plate,
starting pin, and installing the miter gauge to the router table.
ATTACHING THE SWITCH BOX
See Figure 5.
The switch box will come in a bag with the switch box screws
and nuts. Use these screws and nuts in the bag to attach
the switch box.
 Place the router table upside down on a flat surface.
 Hold the switch box so that the words ON and OFF on
the toggle switch are upside down.
 Line up the three holes in the switch box with the three
holes on the outside of the front rail, this is the rail that
is already installed on the front underside of the router
table.
 Insert the switch box screws through the holes in the
switch box and through the holes in the front rail.
 Install the nuts on the back of the switch box screws.
 Holding the screws in place with a screwdriver, tighten
the nuts onto the screws with a wrench or socket.
ATTACHING THE UNDER TABLE GUARDS
See Figure 6.
The under table guards will come in a bag with the under
table guard screws. Use these screws in the bag to attach
the under table guards.
 Place the router table upside down on a flat surface.
 Position the under table guards in front of and behind the
insert plate. The front under table guard should have the
open ended side facing the back of the router table.
 Align the three holes of the under table guards with the
holes in the table. The front under table guard will be
bolted onto the front rail.
 Insert the under table guard screws through the holes
and into the table.
 Tighten screws with a screwdriver.
ATTACHING THE TABLE LEGS
See Figure 7.
The table legs will come in a bag with the table leg screws.
Use the table leg screws in the bag to attach the table legs.
 Place router table upside down on a flat, level surface
with the front edge closest to you.
 Place each leg in a corner of the table. The legs with the
warning labels should go in the front, and the legs without
the warning labels should go in the back.
NOTE: The table leg with the English language warning
should go next to the switch box.
 Align the four holes in the legs with the four corresponding
threaded holes in the table.
 Insert the table leg screws through the holes and into the
table.
ASSEMBLY
SWITCH BOX
SCREW
TABLE GUARDS
TABLE LEG
RIGHT LEG-
FRENCH / SPANISH
LABEL
10
SWITCH KEY
SWITCH BOX
UNDER
TABLE LEG SCREW
FRONT SIDE
LEFT LEG-
ENGLISH LABEL
SWITCH
BOX NUT
FRONT RAIL
Fig. 5
UNDER TABLE
GUARD SCREW
Fig. 6
Fig. 7